论文部分内容阅读
在高温、氢氛下使纤维表面铜盐涂层还原为铜， 通过XRD、SEM和EDS对纤维表面镀层形貌和成分进行了观察与分析，获得的碳纤维表面铜层呈现粒状连续分布，与纤维表面结合过程具有物理和化学的共同特点。
碳纤维表面原位金属化工艺研究
【摘 要】
：
在高温、氢氛下使纤维表面铜盐涂层还原为铜， 通过XRD、SEM和EDS对纤维表面镀层形貌和成分进行了观察与分析，获得的碳纤维表面铜层呈现粒状连续分布，与纤维表面结合过程具有
【机 构】
：
兰州交通大学机电工程学院,甘肃兰州730070
【出 处】
：
第二届中国国际复合材料科技大会 (CCCM-2)
【发表日期】
：
2015年期
其他文献
Deformation coordination of 06Cr19Ni10/Q235 clad composite materials under uniaxial load at room tem
In the present work, 06Cr19Ni10/Q235 clad composite materials are selected as the target materials.Then the deformation behavior, the surface deformation an
会议
The present work studied hot deformation mechanism of powder metallurgy processed 17%vol.SiCp/2009Al composite via hot compression tests.The processing map
会议
Fabrication and properties of Al-based hybrid composites reinforced with SiC micro-particles and SiC
Hybrid reinforced aluminum matrix composites were fabricated by powder metallurgy method, with a controllable volume fraction of micro-sized and nano-sized
会议
In order to study the effects of SiCp size and volume fraction on thermal conductivity of SiCp reinforced aluminum matrix composites, SiCp/2024Al composites
会议
Influence of aging temperature on microstructure and mechanical properties of SiCp/Al-Si matrix comp
The mass fraction of 30% SiC particles reinforced Al-Si matrix composite was prepared by One-way press method, sintering and hot extrusion.The microstructur
会议
The multi-walled carbon nanotubes (CNTs) reinforced Al matrix composites were prepared by Rotational friction extrusion (RFE), And to analyze the microstruc
会议
Effect of interfacial modification on the thermo-physical property of Diamond/Al composites fabricat
In this paper, the molybdenum coating was successfully deposited on the surface of diamond particles by direct current magnetron sputtering method, its surf
会议
为了研究氧化铈(CeO2)对碳化硅颗粒增强铝基复合材料组织与性能的影响,以微米级碳化硅和Al-12Si-Cu-Mg合金粉为原料,添加CeO2,采用粉末冶金法制备碳化硅颗粒增强铝基复合
Mechanical properties of the W fiber reinforced copper materials produced by combustion synthesis me
W fiber reinforced copper materials fabricated by combustion synthesis melt infiltration under ultra-high gravity.Two styles for W fibers were designed.One
会议
For Mg-Li based composites reinforced with boride, besides improving the distribution and quantity of boride reinforced phase in composites, strengthening m
会议