论文部分内容阅读
电视机在更换高压帽时,要将高压引线穿过高压帽的引线孔,当遇到高压帽的引线孔略小于高压引线时,给穿线工作带来一定难度。若在高压引线要穿过的部位涂一点灭弧灵或擦一点蜡,穿线工作极为方便。电视机的高压卡簧要牢固地卡住显像管的高压嘴,一般的方法是用小改锥顶住卡簧的一端向内推压,这种方法往往不能一次到位。若在改锥前端的中间锉成一个“V”形槽,在按放高压卡簧时,用改锥前端的
TV replacement high-pressure cap, it is necessary to high-voltage leads through the high-voltage cap lead hole, when the high-pressure cap leads the hole slightly smaller than the high-voltage leads, threading work to bring a certain degree of difficulty. If the high-voltage lead to the site to be painted a little arc extinguishing Ling or rub a little wax, threading is extremely convenient. TV high-pressure retainer card to firmly stuck high pressure nozzle tube, the general method is to use a small screwdriver against the end of the retainer inward push, this method often can not be in place. If the front end of the screwdriver in the middle of a file into a “V” -shaped groove, press and release the high pressure retainer, with the front of the screwdriver