【摘 要】
：
A novel carbon foam with micropomus structure (CFMS),with the advantages of a simple fabrication process,low energy consumption,large specific surface area and high conductivity,has been prepared by a facile one-step carbonization.In addition,the carbon f
【机 构】
：
School of Physics and Electronics, Hunan University, Changsha 410082, Hunan, China;State Key Laborat
论文部分内容阅读
A novel carbon foam with micropomus structure (CFMS),with the advantages of a simple fabrication process,low energy consumption,large specific surface area and high conductivity,has been prepared by a facile one-step carbonization.In addition,the carbon foam possesses suitable interlayer spacing in short range which is flexible to accommodate the deformation of carbon layer caused by the ion insertion and deinsertion at the charge and discharge state.Furthermore,a low cost carbon-based symmetric potassium dual-ion capacitor (PDIC),which integrates the virtues of potassium ion capacitors and dual-ion batteries,is successfully established with CFMS as both the battery-type cathode and the capacitor-type anode.PDIC displays a superior rate performance,an ultra-long cycle life (90％ retention after 10000 cycles),and a high power density of 7800Wkg-1 at an energy density of 39Whkg-1.The PDIC also exhibits excellent ultrafast charge and slow discharge properties,with a full charge in just 60s and a discharge time of more than 3000 s.
其他文献
K-promoted iron/carbon nanotubes composite (i.e.,FeK-OX) was prepared by a redox reaction between carbon nanotubes and K2FeO4 followed by thermal treatments on a purpose as the Fischer-Tropsch catalyst for the direct conversion of syngas to lower olefins.
The possibility to adjust textural properties of ITH-and IWWzeolites by the variation of conditions (e.g.temperature,pH,duration) of acidic leaching was shown.While the growth of the temperature of acid treatment caused the increasing amount of leached Ge
As a sustainable and short-flow process,iron-catalyzed direct conversion of CO-rich syngas to lower olefins without intermediate steps,i.e.,Fischer-Tropsch-to-Olefins (FTO),has received increasing attention.However,its fundamental understanding is usually
As a new member of carbon material family,carbon quantum dots (CQDs) have attracted tremendous attentions for their potentials in the heterogeneous photocatalysis applications.Due to the unique microstructure and optical properties,the roles of CQDs playe
Nanostructured materials have received tremendous interest due to their unique mechanical/electrical properties and overall behavior contributed by the complex synergy of bulk and interfacial properties for efficient and effective energy conversion and st
The Fischer-Tropsch to olefins (FTO) process is a method for the direct conversion of synthesis gas to lower C2-C4 olefins.Carbon-supported iron carbide nanoparticles are attractive catalysts for this reaction.The catalytic activity can be improved and un
Rechargeable lithium-oxygen (Li-O2) batteries have been considered as the most promising candidates for energy storage and conversion devices because of their ultra high energy density.Until now,the critical scientific challenges facing Li-O2 batteries ar
The Co-based catalysts were prepared with different cobalt acetate solutions.Effects of pH value were studied deeply on Fischer-Tropsch synthesis (FTS) through a semi-batch reactor.Among all impregnation solutions (water,butanol,amyl alcohol,acetic acid,n
A novel mechano-synthesis method has been elaborated in this work for the design of efficient cobaltbased Fischer-Tropsch catalysts.The process aims to reduce the total number of steps involved in the synthesis of solid catalysts and thus to avoid relevan
The present work explores the reaction pathways of γ-valerolactone (GVL) over a supported ruthenium catalyst.The conversion of GVL in aqueous phase over a 5％ Ru/C catalyst was investigated in a batch reactor operating at 463 K under 500-1000 psi of H2.The