Corrosion Resistance of Co-containing Maraging Stainless Steel

来源 :金属学报(英文版) | 被引量 : 0次 | 上传用户:XB_1209WTL
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Corrosion resistance behavior of Co-containing maraging stainless steels was investigated.Neutral salt spray and polarization test showed that maraging stainless steel with high Co content showed poor corrosion behavior.Microstructure observation proved that segregation of Cr in the matrix deteriorated its corrosion resistance.The surface morphology of the aged maraging stainless steel with high Co content indicated that during passivation process,the newly formed passive film with sinusoidal distribution readily destroyed by the corrosive medium,hence,causing poor corrosion resistance.Moreover,through first-principles calculation it was proved that Co increased Fe-Fe ferromagnetic interaction which facilitated the formation Cr-rich clusters.
其他文献
A calculation method based on a combination of △g parallelism rule,good matching site (GMS) analysis,CSL/DSCL (coincidence site lattice/displacement shift complete lattice) and the O-lattice theory has been applied to interpret the observation of the habi
In pressurized water reactor,fretting corrosion has become the main reason for the failure of 690TT heat exchanger tubes.The effect of temperature on the fretting corrosion behavior between 690TT tube and 405 stainless steel (SS) bar has been studied duri
Mg-3Al-1Zn alloy sheets have been deformed by continuous bending (CB) to investigate the effects of processing parameters (bending angle and repetitive passes) on the texture and formability.The samples exhibited a bimodal microstructure with abnormal gro
The microstructure,texture,residual stress,and tensile properties of Mg-6Zn-2Y-1La-0.5Zr (wt%) magnesium alloy were investigated before and after extrusion process,which performed at 300 ℃ and 400 ℃.The microstructural characterizations indicated that the
A modified strain-induced melt activation (SIMA) process consisting of homogenization,equal-channel angular pressing (ECAP) and subsequent heating to the semisolid temperatures was introduced to prepare the 7075 aluminum alloy with superior thixotropic be
The variant selection of martensites (ε-M and α\'-M) and ε-M reversion in dynamic tensile high-manganese TRIP steel were investigated.α\'-M variant pairs with a zigzag morphology frequently formed,and the pairs of neighboring α\'-M variants were exa
The influence of asymmetric reduction rolling (ARR) on the microstructure,texture and mechanical properties of AZ91 was investigated.The microstructural characteristics of the AZ91 sheet processed by symmetric rolling (SR) were the twins,intersection of t
Young\'s modulus is a critical parameter for designing lightweight structure,but Al and its alloys only demonstrate a limited value of 70-72 GPa.The introduction of carbon nanotubes (CNTs) is an effective way to make Al and its alloys stiffer.However,li
The influence of long-term solution treatment for various intervals on the microstructure, mechanical properties, and corrosion resistance of the as-cast Mg-5Zn-1. 5Y alloy was investigated. Variation of secondary phases was studied during solution treatm