论文部分内容阅读
Dielectric Properties of Eu-Doped CaCu3Ti4O12 with Different Compensation Mechanisms
【机 构】
：
State Key Laboratory of Superhard Materials,Jilin University,Changchun 130012,China;Research Center
【出 处】
：
金属学报（英文版）
【发表日期】
：
2017年2期
其他文献
A Fully Coupled Thermomechanical Model of Friction Stir Welding (FSW) and Numerical Studies on Proce
This paper presents a new thermomechanical model of friction stir welding which is capable of simulating the three major steps of friction stir welding (FSW) process,i.e.,plunge,dwell,and travel stages.A rate-dependent JohnsonCook constitutive model is ch
A calculation method based on a combination of △g parallelism rule,good matching site (GMS) analysis,CSL/DSCL (coincidence site lattice/displacement shift complete lattice) and the O-lattice theory has been applied to interpret the observation of the habi
Effects of Temperature on Fretting Corrosion Between Alloy 690TT and 405 Stainless Steel in Pure Wat
In pressurized water reactor,fretting corrosion has become the main reason for the failure of 690TT heat exchanger tubes.The effect of temperature on the fretting corrosion behavior between 690TT tube and 405 stainless steel (SS) bar has been studied duri
Influence of Continuous Bending Process on Texture Evolution and Mechanical Properties of AZ31 Magne
Mg-3Al-1Zn alloy sheets have been deformed by continuous bending (CB) to investigate the effects of processing parameters (bending angle and repetitive passes) on the texture and formability.The samples exhibited a bimodal microstructure with abnormal gro
Evolution of Microstructure, Residual Stress, and Tensile Properties of Mg-Zn-Y-La-Zr Magnesium Allo
The microstructure,texture,residual stress,and tensile properties of Mg-6Zn-2Y-1La-0.5Zr (wt％) magnesium alloy were investigated before and after extrusion process,which performed at 300 ℃ and 400 ℃.The microstructural characterizations indicated that the
Influence of Processing Parameters on Microstructural Evolution and Tensile Properties for 7075 Al A
A modified strain-induced melt activation (SIMA) process consisting of homogenization,equal-channel angular pressing (ECAP) and subsequent heating to the semisolid temperatures was introduced to prepare the 7075 aluminum alloy with superior thixotropic be
The variant selection of martensites (ε-M and α\'-M) and ε-M reversion in dynamic tensile high-manganese TRIP steel were investigated.α\'-M variant pairs with a zigzag morphology frequently formed,and the pairs of neighboring α\'-M variants were exa
The influence of asymmetric reduction rolling (ARR) on the microstructure,texture and mechanical properties of AZ91 was investigated.The microstructural characteristics of the AZ91 sheet processed by symmetric rolling (SR) were the twins,intersection of t
Young\'s modulus is a critical parameter for designing lightweight structure,but Al and its alloys only demonstrate a limited value of 70-72 GPa.The introduction of carbon nanotubes (CNTs) is an effective way to make Al and its alloys stiffer.However,li
Effect of Phase Transformation During Long-Term Solution Treatment on Microstructure, Mechanical Pro
The influence of long-term solution treatment for various intervals on the microstructure, mechanical properties, and corrosion resistance of the as-cast Mg-5Zn-1. 5Y alloy was investigated. Variation of secondary phases was studied during solution treatm