论文部分内容阅读
八四年九月二日至五日,由国家经委、国家科委会同机械部、电子部和江苏省人民政府在南京联合召开了“全国微电子技术改造普通机床现场会”,会上主要介绍了“轰动南京的一项小改革”的内容,即南京微分电机厂和江苏省计算技术研究所合作研制的用单板机改造普通车床的经验。现将这一项小改革的主要内容介绍如下。概括起来就是,在C618普通车床上,采用单板机控制两个步进电机,分别驱动刀架的纵向和横向进给,从而实现对车床自动控制。
From September 2 to August 4, 1984, the State Economic Commission, the State Science and Technology Commission, the Ministry of Machinery, the Ministry of Electronics and the Jiangsu Provincial People’s Government jointly held the “National Conference on the Transformation of General Machine Tools by Microelectronics in Nanjing”, mainly introducing The “sensation of a small reform in Nanjing,” the content of the differential motor factory in Nanjing and Jiangsu Institute of Computing Technology developed by the single-board machine to transform ordinary lathe experience. The main content of this small reform is as follows. To sum up, in the C618 ordinary lathe, the use of single-board machine control two stepper motor, respectively, driven vertical and horizontal turret feed, in order to achieve automatic control of the lathe.