论文部分内容阅读
1.内部带分流通道的喷管该喷管把通过水泵压出的水输送给汽车挡风玻璃清洗机构的两个喷嘴(图1)。其中 A是管接头,与水管与水泵连接。在支架内部,管接头孔与两个引导喷嘴的管道 D 连通。支架由卡子 H 和搭锁 F 固定,加强筋 R 起提高钢性作用。2.模具结构模具设计成四个型腔(图2)。由斜导柱(28)控制的四对拼块(12,13)在卡子和搭锁出模时可分开。拼块(32)是成形部件。模具闭合时,拼块由斜楔(9)
1. Internal Nozzle with Split Channel The nozzle delivers the water that is pumped by the pump to the two nozzles of the car’s windshield washer (Figure 1). Where A is the pipe connector, and the water pipe and pump connection. Inside the holder, the nipple hole communicates with two ducts D that guide the nipple. Bracket by the hook H and snap F fixed stiffener R to enhance the role of steel. 2. Mold structure Mold is designed into four cavities (Figure 2). The four pairs of blocks (12, 13) controlled by the bevel pins (28) are separable when the clips are snap-latched. The tile (32) is a shaped part. When the mold is closed, the tile is composed of wedges (9)