【摘 要】
：
The structure and the hardness of the low carbon steel part based on the rapid prototyping technique of powder plasma arc welding were studied.The deposition experiments were done on the parent metal
【机 构】
：
National Key Laboratory for Remanufacturing,Academy of Armored Forces Engineering,Beijing 100072,Chi
【出 处】
：
第四届国际表面与界面科学与工程学术会议(The Fourth International Conference on S
论文部分内容阅读
The structure and the hardness of the low carbon steel part based on the rapid prototyping technique of powder plasma arc welding were studied.The deposition experiments were done on the parent metal Q235 with the technique of plasma arc welding,the FeNiCrBSiMoNbRe alloy powder was chosen as welding material.The suitable welding parameters were optimized.The structure and the hardness were analyzed.The results of the experiments shown that the microstructure of the weld seam was austenite and δ-ferrite.The grain in the last layer was coarse.,but the grain in the middle layers were fine because every lay in the middle suffered heat affecting of the following layers,So multi-layer welding was help to improve the weld seam microstructure,fine the grain and gained quality structure part.The hardness test shown that substrate hardness was the lowest,The middle weld seam was softened because of the back weld seam temper to the front,and the hardness of the surface layer was the highest,approached to the real hardness of the welding material.
其他文献
Inductively coupled plasma (ICP) system with the adjustable distance (d) between the inductance coil and substrates was designed to effectively utilize the spatial confinement of ICP discharge,and the
TiO2 films were fabricated on Si substrate by using electron-beam gun evaporation.Influence of deposition rate,deposition temperature and ion beam bombarding on stress in TiOh films was studied by AFM
Owing to the advantages of even surface,low cost and simple operation,electroless plating is applied to prepare Ni-Co-P/Si3N4 composite coating on a hyper-eutectic Al-Si casting alloy in this paper.Th
Negative thermal expansion ZrW2O8 thin films have been grown on quartz substrates by pulsed laser deposition (PLD) method using ZrW2O8 ceramic target and annealing subsequently.The influences of annea
ZrB2、AlN coatings and ZrB2/AlN multilayered coatings have been synthesized by ultra-high vacuum IBAD at room temperature.Scanning electron microscopy,X-ray diffraction,XP-2 profiler and Nano indenter
The aim of the present research was to investigate the influence of substrate roughness on structure and mechanical properties of Titanium Aluminium Nitride (TiAlN) coatings.Tungsten Carbide rectangul
TiO2 powders have been successfully synthesized using TiCl4 and air as precursors by atmospheric pressure plasma jet (APPJ),which was powered by a near-square wave high voltage (H.V.) of 8 kV and a fr
CrN thick comings were deposited on silicon (111) by middle-frequency magnetron sputtering system under various parameters.The microstructure was analyzed by X-ray diffraction (XRD),scanning electron
The crystallograpic structure and properties of Zirconium nitride (ZrN) films deposited on 304 stainless steel were investigated for substrates oriented parallel with and perpendicular to the Zirconiu