【摘 要】
：
The thermal-mechanical properties of WHT1300HF high strength steel were tested by isothermal uniaxial tensile methodatvarious strain rates(0.05,0.2,0.5 and 1s-1)and temperatures(700.750,800 and 850℃)a
【机 构】
：
NVH & Material Performance Development Division,Geely Automobile Research Institute;School of Materi
论文部分内容阅读
The thermal-mechanical properties of WHT1300HF high strength steel were tested by isothermal uniaxial tensile methodatvarious strain rates(0.05,0.2,0.5 and 1s-1)and temperatures(700.750,800 and 850℃)and analyzed by constitutive equations.The results show that increasing deformation temperature leads to significant reduction in the level of flow stress and work hardening exponent of the steel; however,increasing strain rate results in noticeable increase in the stress level and work hardening.Arrhenius-type constitutive equations were used to describe the flow behavior of the steel at elevated temperatures.With the constants of n,α,ln A and Q determined by the approximation method,the relative error between the calculated and tested flow stresses is smaller than 5.15%,suggesting a high level of confidence in the developed constitutive equations.
其他文献
Based on the history of multi-step stamping,an advanced analysis method is proposed to analyze the structural properties of metal part.This method combines multi-step stamping forming and structure an
Minimum quantity lubricant(MQL)now becomes a development direction of mechanical manufacturing technology,for its advantages in environmental protection,cost and occupational health.It introduces appl
Through analyzing reports of the complains and the test results collected from Hainan nearly 10 years,It could be found out that the area of the body where corrosion happens is more concentrated and t
A full-variable-valvetrain prototype named Dual UniValve System has been developed for a GDI engine with SI/HCCI dual combustion modes,improving the fuel economy and emission performance under some of
Steady state flow tests of different tumble intake ports matched with different S/V(surface-to-volume ratio)combustion chambers have been carried out.The results show that the flow coefficient of a me
Lane changing and merging occurs more frequently in work zones than other roadway conditions due to mandatory lane changes that occur in work zones with lane closures.Discretionary lane changes are al
Two phase emergency dispatch algorithm which treats failed customer and failed route individually is put forward in this thesis,which is based on reason analysis of why urban pickup and delivery task
The Software defined radios(SDR)concept [1,2] suggests that future radio systems will support multi-standard,multimode and multiband wireless communications.As described in the survey [ 3 ],this techn
CNTs contents of 5wt%.,1Owt%,15wt%,20wt%PTMSDPA/CNTs hybrid composite membranes were prepared by a solution-casting method and the effect of structure and content of CNTs on gas separation and pervapo
The advanced high strength steel B pillar was designed to be a tailored blank component which combines tailor welded blanks with tailor rolled blanks.and the formability of the B pillar was studied th