【摘 要】
：
Many simple nonlinear main journal bearing models have been studied theoretically, but the connection to existing engineering system has not been equally invest
【机 构】
：
State Key Laboratory of Engine,Tianjin Internal Combustion Engine Research Institute
【基金项目】
：
国家自然科学基金;国家高技术研究发展计划(863计划)
论文部分内容阅读
Many simple nonlinear main journal bearing models have been studied theoretically, but the connection to existing engineering system has not been equally investigated. The consideration of the characteristics of engine main journal bearings may provide a prediction of the bearing load and lubrication. Due to the strong non-linear features in bearing lubrication procedure, it is difficult to predict those characteristics. A non-linear dynamic model is described for analyzing the characteristics of engine main journal bearings. Components such as crankshaft, main journals and con rods are found by applying the finite element method. Non-linear spring/dampers are introduced to imitate the constraint and supporting functions provided by the main bearing and oil film. The engine gas pressure is imposed as excitation on the model via the engine piston, con rod, etc. The bearing reaction force is calculated over one engine cycle, and meanwhile, the oil film thickness and pressure distribution are obtained based on Reynolds differential equation. It can be found that the maximum bearing reaction force always occurs when the maximum cylinder pressure arises in the cylinder adjacent to that bearing. The simulated minimum oil film thickness, which is 3 μm, demonstrates the reliability of the main journal bearings. This non-linear dynamic analysis may save computing efforts of engine main bearing design and also is of good precision and close connection to actual engine main journal bearing conditions.
其他文献
There are often many inter-harmonics in power system.The high measurement accuracy of inter-harmonics order, amplitude and initial phase is needed. A new approa
A high current radio frequency quadrupole (RFQ) is being studied at the Institute of Modern Physics,Chinese Academy of Sciences (IMP,CAS) for the direct plasma
This paper analyzes the geometric quantities that remain unchanged during parallel mapping (i.e., mapping from a reference curved surface to a parallel surface
To investigate the exon mutation of vitamin K-dependent gamma-glutamyl carboxylase (GGCX or VKDC) in patients with calcium oxalate urolithasis, renal cortex and
Aimed at deficiencies in the development and implementation of Enterprise Service Architecture (ESA)software,an ESA software developing mode based on Model Driv
Granular matter is a large assemblage of solid particles,which is fundamentally different from any other type of matters,such as solid and liquid.Most models pr
Secretome,the totality of secreted proteins,is viewed as a promising pool of candidate cancer biomarkers.Simple and reliable methods for identifying secreted pr
An optimum design model has been proposed for carbon/carbon ablative property based on genetic algorithm,in which the optimum parameters are the number of woven
In this paper, the wind load on an arc-shaped canopy roof was studied with numerical wind tunnel method(NWTM). Three-dimensional models were set up for the cano
In mod manufacturing patt, there are many uncertain factors in the mod manufacturing process, such as changes of product attribute, changes of manufacturing res