论文部分内容阅读
拆下油泵和离合齿套后,对相关零件进行了检查,发现离合齿套有锈蚀,手柄臂销孔稍偏,但问题不大。再仔细检查,发现离合齿套外表面距凹槽边缘1毫米 (1)调整好位置应根据起动者高矮来调整人的重心,能使摇手柄在最高与最低位置范围内顺手操作。 (2)先缓后急刚起动瞬间,各运动副摩擦表面处于干摩擦和半干摩擦,摩擦阻力矩较大,因此刚开始摇转曲轴时一定要慢,这样不仅减少磨损,而且减小阻力,
Remove the pump and clutch gear sets, the relevant parts were inspected and found that there is rust gear clutch, handle arm pin hole slightly off, but the problem is not. Careful examination and found that the clutch gear outer surface from the edge of the groove 1 mm (1) adjust the position should be based on the height of the starter to adjust the center of gravity, can shake the handle in the highest and lowest position within the range of easy operation. (2) Immediately after the start of emergency immediately after the start of the moment, the movement of the friction surface in the dry friction and semi-dry friction, friction torque larger, so just cranking crankshaft must be slow, so not only reduce wear and tear, and reduce resistance ,