论文部分内容阅读
压力机的选用是冷冲模设计中的一个重要环节。根据“冷冲模设计手册”介绍的计算公式去校核压力机是否满足冲压工艺要求时,要经过两次计算才能求出滑块处于某高度瞬时的极限压力值来。第一步计算滑块行程
The choice of press is an important part of the die design. According to “Die Design Manual,” describes the calculation formula to check whether the press meets the stamping process requirements, to go through two calculations in order to find the slider at a certain height instantaneous pressure limit. The first step is to calculate the slider stroke