【摘 要】
：
The damage behaviors of a titanium matrix composite shaft under torsion loading were monitored using the acoustic emission technique.The composite shaft with SiC fibers at ± 45° orientations was prepared by the solid-state fabrication process.Both the tor
【机 构】
：
Institute of Metal Research, Chinese Academy of Sciences,Shenyang 110016, China;University of Chines
论文部分内容阅读
The damage behaviors of a titanium matrix composite shaft under torsion loading were monitored using the acoustic emission technique.The composite shaft with SiC fibers at ± 45° orientations was prepared by the solid-state fabrication process.Both the torsional rigidity and torsional strength of the TMC shaft were improved by SiC fibers.The acoustic emission responses during the loading-unloading-reloading,under quasi-static and cyclic torsion tests were investigated.Multiple acoustic emission signals were grouped as mechanical noise,matrix deformation,interface debonding and fiber fracture using amplitude,waveform shape and frequency centroid parameters.A substantial reduction of signals generated by matrix deformation was found in the reloading test.During the quasi-static torsion test,interface debonding and progressive breaks of SiC fibers occurred.According to different acoustic emission behaviors,the failure process in the torsion fatigue test can be divided into three stages:the initial stage,the fiber fracture stage and the fast fracture stage.
其他文献
As-extruded Mg-Sr alloy,a kind of promising biodegradable biomedical material,was coated using micro-arc oxidation and also using a phosphate conversion coating.The corrosion behaviors were investigated using Hanks\' solution.The corrosion of the as-ext
This work discusses tribological properties of commercial pure (CP) titanium processed by multi-directional forging (MDF) up to six passes at room temperature and 220 ℃.For this purpose,wear test was conducted by dry sliding pin-on-disk method on the init
The microstructural evolution of pure nickel treated by deep rolling (DR) technique with different indent depths was investigated by means of optical microscopy and transmission electron microscopy.The surface roughness,hardness and residual stress distri
The synergistic effect of NaC1 and SO2 on the atmospheric corrosion of zinc has been studied at equivalent total but different ratios of molar deposition rate under wet-dry cyclic conditions.The results show that the corrosion rates,corrosion morphologies
Carbon fiber reinforced plastics (CFRP) are promising lightweight materials for vehicle applications.316L is one of the most widely used types of austenite stainless steels and applied in lots of automotive applications.The existence of crevices will resu
The present work describes the effect of deposition potentials on structural,morphological,optical,electrical and photoconductivity responses of cuprous oxide (Cu2O) thin films deposited on fluorine-doped tin oxide glass substrate by employing electrodepo
The surface of AISI 1045 steel specimens was modified via two duplex surface treatments of (i) titanium diffusion coating followed by plasma nitriding (Ti-PN) and (ii) plasma nitriding followed by titanium diffusion coating (PN-Ti).A comparative study on
Type I hot corrosion behavior of SiO2-Al2O3-glass composite coating based on Ti-47Al-2Cr-2Nb substrate was investigated in the mixture salt of 25 wt％NaCl + 75 wt％Na2SO4 at 850 ℃.The results showed that there was a bidirectional ion exchange between compos
Mg-Zn-Zr series Mg alloys (ZK) are one of the most important commercial Mg alloys due to their good comprehensive mechanical properties.The phase equilibria of the Mg-Zn-Zr system at 400 ℃ covering the overall composition range were investigated by X-ray
In the present study,a quenching treatment prior to two-stage heat treatment was conducted on a Fe-0.28C-1.55Mn-2.06Al transformation-induced plasticity steel to tailor the final microstructure.Compared with the microstructure of the ferrite,bainite and b