【摘 要】
：
The microstructural evolution of pure nickel treated by deep rolling (DR) technique with different indent depths was investigated by means of optical microscopy and transmission electron microscopy.The surface roughness,hardness and residual stress distri
【机 构】
：
Key Laboratory of Pressure Systems and Safety, Ministry of Education, School of Mechanical and Power
论文部分内容阅读
The microstructural evolution of pure nickel treated by deep rolling (DR) technique with different indent depths was investigated by means of optical microscopy and transmission electron microscopy.The surface roughness,hardness and residual stress distribution along the depth from surface were measured.Moreover,the DR-treated sample was annealed at temperatures from 300 to 700 ℃ for 2 h.The results reveal that dislocation movements are the fundamental mechanisms of gradient grain refinement during the DR process.With increasing indent depth of the DR,the gradient microhardness on the cross section of sample significantly increases,the maximum compressive residual stress decreases,and the affecting region of residual stress increases.The results of thermal stability depict that the microstructure can be stable as temperature up to 300 ℃,and the abnormal grain growth and annealing twins are observed at 600 ℃.
其他文献
In this study,powder mixtures containing (Ti,W)C additions (10,20,30 and 40 wt％) were prepared and then consolidated at 1200,1250,1300 and 1350 ℃ by spark plasma sintering.The effect of (Ti,W)C additions on the microstructure and mechanical properties of
The effect of pH on the electrochemical behaviour and passive film composition of 316L stainless steel in alkaline solutions was studied using electrochemical measurements and a surface analysis method.The critical pH of 12.5 was found for the conversion
A CoCrFeMnNi high-entropy alloy with a high content of carbon was synthesized,and its hot deformation behavior was studied at the temperatures 800-1000 ℃ at the strain rates ranging from 0.001 to 0.1 s-1.As-prepared alloy is a face-centered cubic-structur
The effect of short-time aging in the temperature range between 400 and 1000 ℃ on the pitting corrosion behavior and mechanical property of a novel lean duplex stainless steel (LDSS) 2002 was investigated through the potentiostatic critical pitting temper
The influence of Fe on the microstructure and mechanical properties of P-doped Ni-Cr-Fe alloys has been investigated.Results showed that increasing Fe content refined the dendrite microstructure and enhanced the solubility of P in as-cast alloys.The chang
Tensile properties,microstructural evolution and fracture toughness of Al 2014 alloy subjected to cryorolling followed by warm rolling (CR + WR) have been investigated in the present study.The solution-treated (ST) Al 2014 alloy is cryorolled followed by
The Ni3Al-based superalloy was rapidly solidified in the form of droplets with varying diameters.The cooling rate (Re) is a function of diameter (D) of droplet.With the decrease in droplet sizes (increase in the cooling rates),the volume fraction of γ\'
Compared to the traditional one-by-one method,a new high-efficiency method is used to characterize large numbers of regulations varying samples.Accordingly,bump-shaped electrodes are designed using the computational fluid dynamics model,and the effect of
As-extruded Mg-Sr alloy,a kind of promising biodegradable biomedical material,was coated using micro-arc oxidation and also using a phosphate conversion coating.The corrosion behaviors were investigated using Hanks\' solution.The corrosion of the as-ext
This work discusses tribological properties of commercial pure (CP) titanium processed by multi-directional forging (MDF) up to six passes at room temperature and 220 ℃.For this purpose,wear test was conducted by dry sliding pin-on-disk method on the init