论文部分内容阅读
橡皮树繁殖方法主要有扦插和高压二种,其中高压繁殖以其成活率高、成型快而倍受养花爱好者青睐。但是由于橡皮树皮层厚、木质脆,在实施高压过程中极易折断,因此笔者近几年对传统的塑膜高压繁殖法进行改进,采用棉絮塑膜包裹法,取得令人满意的效果。这种方法不仅简单易行,而且形成愈伤组织早、生根快,一般20天即可见到白根外露。材料准备:清洁卫生的棉絮(用市场所售普通棉絮也可),用开水冲泡10～20分钟,捞起备用。用于包裹的塑膜,采用普通农用地膜即可,先用柱状物卷起若干层,并剪成3～4厘米段状。操作过程:一般在橡皮树的旺长期伏季进行,根据所需树型,在相应部位去掉1～2片叶子进行环剥。直径1厘米的树干剥口宽1.5厘米左右,环剥处流出的白色树汁是否冲洗,影响不大。把存有一定水
Rubber tree breeding methods are mainly two kinds of cutting and high pressure, of which high-pressure breeding with its high survival rate, forming fast and much favored flower-lovers. However, due to the rubber bark layer thick, wood crisp, easy to break in the implementation of high pressure process, so I in recent years the traditional plastic film high pressure propagation method to improve the use of cotton plastic film parcel method, and achieved satisfactory results. This method is not only simple and easy, and the formation of callus early, rooting fast, usually white roots can be seen within 20 days of exposure. Material Preparation: clean cotton (ordinary cotton floss available at the market can also), with boiling water for 10 to 20 minutes, picked up spare. Plastic film used for parcels, the use of ordinary agricultural film can be used to roll up a number of layers with pillars, and cut into 3 ~ 4 cm segment. Operation process: Usually in the long-term volleyball season wedges, according to the desired tree, remove 1 to 2 leaves in the corresponding parts of the girdling. The diameter of 1 cm trunks wide strip about 1.5 cm wide, girdling at the outflow of white sap whether to flush, little effect. There is a certain amount of water