【摘 要】
：
The influence of surface pre-treatments, shot-peening (SP) and laser remelting (LR), on oxygen permeation behaviors of titanium alloy TC11 was investigated. Opt
【机 构】
：
State Key Laboratory for Corrosion and Protection,Shenyang Liming Aero-engine Group Corporation
论文部分内容阅读
The influence of surface pre-treatments, shot-peening (SP) and laser remelting (LR), on oxygen permeation behaviors of titanium alloy TC11 was investigated. Optical microscope, SEM with EDAX, XRD, and microhardness tester were employed to characterize the microstructure, composition and hardness of this alloy. The results show that the surface roughness is increased by shot-peening, and the microstructure with fine-grain can be obtained by LR pre-treatment. The pre-treated samples were oxygen-permeated at (810± 10) ℃ for 10 h in atmospheric air. The outer layer consists essentially of TiO2, trace Ti2 N, Ti3Al and Ti3AlN for the SP pre-treatment and thin oxygen solution layer is found in the subsurface layer. As for LR pre-treatment, the outer layer consists mainly of TiO2 and small amounts of TiO, and the inner layer consists of alpha crystals, rich in interstitial atoms. Samples by LR pre-treatment has thicker hardened layer with higher hardness values in comparison with SP pre-treated ones.The boost diffusion of oxygen and hardening mechanisms were discussed based on the experimental results.
其他文献
CO2 laser quick assembly technology is adopted on the surface of cast aluminum ZL104 to form a dense ceramic coating containing a great deal of nanometer Al2O3/
Low-Co AB5-type Mm(NiCoMnA1)5Bx (x = 0, 0.1, 0.2 ) electrode alloys were prepared by casting and rapid quenching.The effects of the rapid quenching on the latti
A new concept of salt core, a melting temperature of which is lower than the solidus temperature of cast alloy,was introduced to produce an integrated casting p
In order to improve the in-flight characteristics of the atomizing droplets during high velocity wire arc spraying (HVAS), some changes have been operated on th
The content of zirconia has a remarkable influerce on transformation behavior and mechanical properties of Al2O3/ZrO2 (2Y) composites. When 15% and 20% ZrO2(2Y)
In the present work investigations have been made to see the role of metal oxides on the performance of the silver metal oxides electrical contact materials. Si
Recent research activities on the formation of micro-defects and porosity in organic coatings were reviewed. The mechanisms of aggressive ionic conduction throu
The oxidation of specimens with thermal barrier coating (TBC) consisted of nickel-base superalloy, low-pressure plasma sprayed Ni-28Cr-6Al-0.4Y (wt pct) bond co
The n-SiO2/Ni composite electro-brush plating coating was prepared on the 1045 steel substrate. SEM and TEM were utilized to analyze the surface and cross-secti
In research of YBCO coated conductors, the development of a oxide template for epitaxial growth of YBCO is very important. Matsumoto et al have demonstrated the