论文部分内容阅读
1.从树脂条上切下脚垫的形状。在你的模型上比一下它们的大小并把树脂片弯曲成形。形状正确之后,用砂棒将边角打磨圆滑。2.在牙签上涂强力胶,用它将电线围绕在脚垫的外缘粘接起来,这是起装饰作用的。3.如果把胶弄到脚垫上或是装饰做得并不十分规整,别担心,只要确保装饰条牢固地粘在树脂片上就可以了。当胶干了之后,打磨那些不完美的地方。4.这些都完成了,把两片脚垫放到位检测一下,看排列和曲度是否合适。5.用适当的颜色喷涂脚垫。棉毛材料可以掩盖住喷涂的瑕疵,所以脚垫可以用手涂。6.用一支好毛笔将水稀释后的白胶覆盖住脚垫。注意不要把胶弄到装饰条上。7.筛选一些棉毛料用在脚垫上,晾置30分钟。到胶全干了之后,用手指轻轻地按压棉毛料。8.快做完了！再把棉毛料从脚垫上取下,过夜晾干。现在它们看起来像真的一样！这样的脚垫可以提升内部的真
1. Cut the shape of the foot pad from the resin strip. Compare your size with your model and bend the resin sheet. After the shape is correct, smooth the corners with sand sticks. 2. Apply a strong glue on the toothpick, use it to wire around the outer edge of the mat bonding, which is decorative. 3. If you get the glue on the mat or the decoration is not very structured, do not worry, just make sure that the decorative bar firmly stuck to the resin on it. When the glue is dry, polish those imperfections. 4. These are done, put two feet put in place to test to see if the alignment and curvature is appropriate. 5. Spray mat with proper color. Cotton material can mask the spray defects, so the mat can be painted by hand. 6 with a good brush to dilute the water after the white plastic cover foot pad. Be careful not to get the glue on the trim. 7. Screen some cotton wool material used in the mat, dry for 30 minutes. After the glue is completely dry, gently press the cotton wool material with your fingers. 8. Almost done! Then remove the cotton wool material from the mat, overnight to dry. Now they look exactly the same! Such a foot pad can improve the inner real