论文部分内容阅读
针对铝型材氧化电泳表面处理的高能耗现状,扼要地介绍了氧化电泳过程氧化硅机采用水冷却节能技术、电泳定库仑量设定法节电技术和氧化电泳阴极板材质选择的节电技术。经生产实践表明,技术上可行,并具有显著节能降耗效果,产生的经济效益显著。
铝型材氧化电泳的低碳技术与应用
【摘 要】
：
针对铝型材氧化电泳表面处理的高能耗现状,扼要地介绍了氧化电泳过程氧化硅机采用水冷却节能技术、电泳定库仑量设定法节电技术和氧化电泳阴极板材质选择的节电技术。经生产
【机 构】
：
广东坚美铝型材厂有限公司
【出 处】
：
铝加工
【发表日期】
：
2010年6期
其他文献
Friction and sliding wear behaviour of Ti-B-N coatings against AISI440C steel ball and WC-6wt%Co ball were studied by using pin-on-disk tribometer along with mi
A wear resistant (Cr, Fe)7C3/γ-Fe ceramal composite coating wasfabricated on substrate of a 0.45%C carbon steel by plasma transferred arc (PTA) cladding proces
DEPENDENCE OF MICROSTRUCTURE SCALES OF EUTECTICS ON Ca-Si MODIFIER AMOUNT IN AUSTENITE STEEL COMPOSI
Results presented in this paper contribute to investigation of the effect of the added Ca-Si modifier amount (αk) on the microstructure scales of granular γ-(
Blank holder force (BHF) is an important measure to control the sheet metal forming.BHF is identified quickly using artificial neural network (ANN) on the basis
The influence of alloy composition (Ti, Mn, TiN) on hydrogen diffusion in Fe was studied in detail using SCM-DV-Xα method. The voltage barriers were obtained v
The effect of different peak temperature (Tp) and cooling time (ts/5) on hardness,impact toughness and fracture morphology in the heat-affected zone (HAZ) of HQ
近日，西南铝业（集团）有限责任公司锻造厂研制出国产某型号飞机用超长弧形自由锻件，填补了国内超长弧形锻件生产空白。广大技术人员通过结合前期为该型号飞机提供实验材料的成功经
研究利率期限反映收益率与期限之间的关系,其重要性随着我国经济的不断发展、经济金融各方面创新的持续改革而不断加强,所以,本文将针对针对国债利率期限,建立分析利率期限结
The growth process of low-temperature plasma-nitriding layer was investigated by scanning electron microscopy(SEM)and X-ray diffraction(XRD).The layer is compos
The mechanisms of La in heavy rail steel were studied by means of experimental measurements,microstructure observation and theoretical analysis in the present w