EFFECTS OF La ON STRUCTURE AND PROPERTIES OF HEAVY RAIL STEEL

来源 :金属学报：英文版 | 被引量 : 0次 | 上传用户：c0128

【摘要】

：

The mechanisms of La in heavy rail steel were studied by means of experimental measurements,microstructure observation and theoretical analysis in the present w

【作者】

：

C.J. Liu M.F. Jiang Y.S. Wang

【机构】

：

NortheasternUniversity,BaotouIronandSteelGroupGorporation

【出处】

：

金属学报：英文版

【发表日期】

：

2005年6期

【关键词】

：

重轨钢硫化物夹杂显微结构性能稀土 rare earth heavy rail steel microscopic structure sulfi

【基金项目】

：

中国科学院资助项目

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

The mechanisms of La in heavy rail steel were studied by means of experimental measurements,microstructure observation and theoretical analysis in the present work. For heavy rail steel, the state and the content of La were measured, and the mechanisms an

其他文献

Al-Li-Sc热轧板制备工艺

本专利介绍了一种可焊、高强、各向同性Al-Li合金热轧板的制备工艺。该合金铸坯的成分构成（质量分数，%）为：Li(1.5～3.0)，Cu(1.0～4.0)，Sc(>0.2～10.0)，Si(0.03～1.0)，Fe(0.03～1.0)，Mn(0.05～1.0)，M

期刊

制备工艺热轧板AL-LI合金加工状态结晶状态固溶热处理半成品专利介绍

COMPOSITION EFFECT ON DRY SLIDING WEAR BEHAVIORS OF Ti-B-N THIN FILMS

Friction and sliding wear behaviour of Ti-B-N coatings against AISI440C steel ball and WC-6wt%Co ball were studied by using pin-on-disk tribometer along with mi

期刊

干燥滑行磨损摩擦系数氧化腐蚀钛-硼-氮薄膜电镀合金钢dry sliding wear friction coefficient oxidation

STUDY ON PTA CLAD （Cr, Fe）7C3/γ-Fe CERAMAL COMPOSITE COATING

A wear resistant (Cr, Fe)7C3/γ-Fe ceramal composite coating wasfabricated on substrate of a 0.45%C carbon steel by plasma transferred arc (PTA) cladding proces

期刊

(CrFe)7C3/γ-Fe等离子弧喷涂金属陶瓷显微结构显微硬度plasma transferred arc （ PTA ） cladding （

DEPENDENCE OF MICROSTRUCTURE SCALES OF EUTECTICS ON Ca-Si MODIFIER AMOUNT IN AUSTENITE STEEL COMPOSI

Results presented in this paper contribute to investigation of the effect of the added Ca-Si modifier amount (αk) on the microstructure scales of granular γ-(

期刊

微观结构奥氏体钢CaSi共晶定向凝固austenite steel eutectic microstructure directional s

DETERMINATION OF BLANK HOLDER FORCE IN SHEET METAL DEEP DRAWING PROCESS

Blank holder force (BHF) is an important measure to control the sheet metal forming.BHF is identified quickly using artificial neural network (ANN) on the basis

期刊

板材成形拉延冲压力blank holder forcesheet metal deep drawingartificial neural networ

INFLUENCE OF ALLOYING ELEMENTS ON HYDROGEN DIFFUSION USING SCM-DV-Xα

The influence of alloy composition (Ti, Mn, TiN) on hydrogen diffusion in Fe was studied in detail using SCM-DV-Xα method. The voltage barriers were obtained v

期刊

SCM-DV-Xα合金元素扩散氢合金钢hydrogen diffusion SCM-DV-Xα method cluster

EFFECTS OF THERMAL CYCLE ON MECHANICAL PROPERTIES AND FRACTOGRAPHY IN HAZ OF HQ130 STEEL

The effect of different peak temperature (Tp) and cooling time (ts/5) on hardness,impact toughness and fracture morphology in the heat-affected zone (HAZ) of HQ

期刊

HQ130钢高强度钢焊接热影响区机械性能热循环显微观察high strength steelwelding thermal cyclehe

西南铝成功产出飞机用超长弧形自由锻件

近日，西南铝业（集团）有限责任公司锻造厂研制出国产某型号飞机用超长弧形自由锻件，填补了国内超长弧形锻件生产空白。广大技术人员通过结合前期为该型号飞机提供实验材料的成功经

期刊

西南铝业(集团)有限责任公司自由锻件弧形机用国产飞机锻件生产铝合金材料成功经验

利率期限结构模型分析

研究利率期限反映收益率与期限之间的关系,其重要性随着我国经济的不断发展、经济金融各方面创新的持续改革而不断加强,所以,本文将针对针对国债利率期限,建立分析利率期限结

期刊

利率期限结构NSNSS

GROWTH PROCESS OF LOW-TEMPERATURE PLASMA-NITRIDING LAYER ON AUSTENITIC STAINLESS STEEL

The growth process of low-temperature plasma-nitriding layer was investigated by scanning electron microscopy(SEM)and X-ray diffraction(XRD).The layer is compos

期刊

奥氏体不锈钢低温等离子体渗氮涂层生长过程XRDSEMaustenitic stainless steelplasma nitridingsl

EFFECTS OF La ON STRUCTURE AND PROPERTIES OF HEAVY RAIL STEEL

其他学术论文