METALAP 2019

来源 :中国铸造:英文版 | 被引量 : 0次 | 上传用户：baijiw

【摘要】

：

Asia-Pacific Metal Industry Exhibition 2019.12.12-14 BITEC, Bangkok, ThailandBECOME EXHIBITOR NOW.Organized by China Foundry Productivity Promotion Center Indus

【出处】

：

中国铸造:英文版

【发表日期】

：

2019年1期

【关键词】

：

METALAP 2019

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

Asia-Pacific Metal Industry Exhibition 2019.12.12-14 BITEC, Bangkok, ThailandBECOME EXHIBITOR NOW.Organized by China Foundry Productivity Promotion Center Industrial Furnace Institution of CMES Metallurgical Council of CCPIT Managed by Foundry Institution

其他文献

Microstructure and tensile properties of thixo-diecast AZ91D magnesium alloy

The thixo-diecasting(TDC)process is the combination of semi-solid billet preparation technology and die casting technology.The TDC process not only keeps the ch

期刊

An investigation on bonding interface microstructure of ceramic coating prepared on AZ91D by evapora

PbO-ZnO-Na2O 陶器的涂层被扔的蒸发的模式(EPC ) 使用过程在 AZ91D Mg 合金底层表面上制作。陶器的涂层通过扫描电子显微镜学(SEM ) 被描绘观察，精力散 X 光检查分光计(版本)

期刊

镁合金陶器的涂层蒸发了模式扔分解产品结合的接口magnesium alloy ceramic coating evaporated pattern c

Application of digital pattern-less molding technology to produce art casting

Compared with the conventional casting process, digital pattern-less casting technology has many advantages such as good machining accuracy, a short processing

期刊

Influence of Si content and heat treatment on microstructure of Al-Fe-Si alloys

The effect of Si addition and heat treatment on the Al-5wt.%Fe alloy has been investigated by OM, SEM-EDS and XRD. The results show that the Si plays a signific

期刊

Defect production and atomic mixing by displacement cascades in Ni<sub>3</sub>Al

Molecular dynamics simulations have been employed to investigate displacement cascades in Ni3Al, with energy Ep in the range from 0.15 to 10 keV. The efficiency

期刊

NI3ALdisplacementCASCADESDEFECTproductionATOMICMIXINGmoleculardynamics.

Effect of compound field on horizontal continuous casting of Al-1wt.%Si alloy

A travelling magnetic field, a power ultrasonic field, and a compound field were used separately during the horizontal continuous casting process of Al-1wt.%Si

期刊

Separation of primary Si and impurity boron removal from Al-30%Si-10%Sn melt under a traveling magne

Separation of primary Si phase and removal of boron in the primary Si phase during the solidification process of the Al-30%Si-10%Sn melt under a traveling magne

期刊

travelingmagneticfieldAl-Si-SnalloyBORONsolidificationrefiningsolidifica

Influence of heat treatment on microstructure and tensile properties of a cast Al-Cu-Si-Mn alloy

Solution and aging treatments are important approaches to improve mechanical properties and microstructure of aluminum-base alloys. In this research, a new type

期刊

Dry sliding wear characterization of squeeze cast LM13/Fe Cu composite using response surface method

期刊

Effects of Sm addition on microstructure and mechanical properties of a Mg-10Y alloy

To further increase the mechanical properties, 0.5wt.% Sm was introduced to a Mg-10Y alloy in this study. The effects of Sm addition on the microstructures and

期刊

METALAP 2019

其他学术论文