• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 期刊论文
  5. Influence of heat treatment on microstructure and tensile properties of a cast Al-Cu-Si-Mn alloy

Influence of heat treatment on microstructure and tensile properties of a cast Al-Cu-Si-Mn alloy

来源 :中国铸造：英文版 | 被引量 : 0次 | 上传用户：sharkzw
【摘 要】
：
Solution and aging treatments are important approaches to improve mechanical properties and microstructure of aluminum-base alloys. In this research, a new type
【作 者】
：
Liu Zhixue Dang Long Cheng Juq 
【机 构】
：
ShaanxiKeyLaboratoryofPhotoelectricFunctionalMaterialsandDevices
【出 处】
：
中国铸造：英文版
【发表日期】
：
2013年6期
【基金项目】
：
This research was financially supported by the National Natural Science Foundation of China （No,51371133）.
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Solution and aging treatments are important approaches to improve mechanical properties and microstructure of aluminum-base alloys. In this research, a new type high strength Al-Cu-Si-Mn cast alloy was prepared. The effect of different solution and aging
其他文献
"FOSECO"Cup Best Papers Published in CHINA FOUNDRY and Winners
Jing-an Yang,Ph.D.,School of Materials,Tsinghua University.His main research area is ingot casting process simulation.The graduation thesis was entitled "Experi
期刊
FOSECOCHINAFOUNDRYTsinghuaUNIVERSITYJing-anYang
CHINA FOUNDRY Editorial Board
期刊
Temperature-induced liquid state change and its effects on solidification of thermoelectric alloy Bi
The behaviors of electrical resistivity vs temperature(ρ-T) of the molten p-type thermoelectric alloy Bi0.3Sb1.7Te3(at.%) were explored in heating and cooling
期刊
Microstructure and tensile properties of thixo-diecast AZ91D magnesium alloy
The thixo-diecasting(TDC)process is the combination of semi-solid billet preparation technology and die casting technology.The TDC process not only keeps the ch
期刊
An investigation on bonding interface microstructure of ceramic coating prepared on AZ91D by evapora
PbO-ZnO-Na2O 陶器的涂层被扔的蒸发的模式(EPC ) 使用过程在 AZ91D Mg 合金底层表面上制作。陶器的涂层通过扫描电子显微镜学(SEM ) 被描绘观察，精力散 X 光检查分光计(版本)
期刊
镁合金陶器的涂层蒸发了模式扔分解产品结合的接口magnesium alloy ceramic coating evaporated pattern c
Application of digital pattern-less molding technology to produce art casting
Compared with the conventional casting process, digital pattern-less casting technology has many advantages such as good machining accuracy, a short processing
期刊
Influence of Si content and heat treatment on microstructure of Al-Fe-Si alloys
The effect of Si addition and heat treatment on the Al-5wt.%Fe alloy has been investigated by OM, SEM-EDS and XRD. The results show that the Si plays a signific
期刊
Defect production and atomic mixing by displacement cascades in Ni<sub>3</sub>Al
Molecular dynamics simulations have been employed to investigate displacement cascades in Ni3Al, with energy Ep in the range from 0.15 to 10 keV. The efficiency
期刊
NI3ALdisplacementCASCADESDEFECTproductionATOMICMIXINGmoleculardynamics.
Effect of compound field on horizontal continuous casting of Al-1wt.%Si alloy
A travelling magnetic field, a power ultrasonic field, and a compound field were used separately during the horizontal continuous casting process of Al-1wt.%Si
期刊
Separation of primary Si and impurity boron removal from Al-30%Si-10%Sn melt under a traveling magne
Separation of primary Si phase and removal of boron in the primary Si phase during the solidification process of the Al-30%Si-10%Sn melt under a traveling magne
期刊
travelingmagneticfieldAl-Si-SnalloyBORONsolidificationrefiningsolidifica