【摘 要】
：
During the splitting spinning process,the material parameters of disk blank have a significant effect on the determination of forming parameters and the quality
【机 构】
：
School of Materials Science and Engineering
论文部分内容阅读
During the splitting spinning process,the material parameters of disk blank have a significant effect on the determination of forming parameters and the quality of deformed blank.The influence laws of material parameters,including yield stress.hardening exponent and elastic modulus,on splitting spinning force,splitting spinning moment,degree of inhomogeneous deformation and quality of flange (average thickness and average deviation angle) were investigated by 3D-FE numerical simulation based on elasto-plastic dynamic explicit FEM under ABAQUS/Explicit environment.The results show that.the splitting spinning force and the splitting spinning moment increase wim the increase of yield stress.hardening exponent and elastic modulus.The degree of inhomogeneous deformation increases with the decrease of yield stress and hardening exponent and the increase of elastic modulus.The average thickness of flange increases with the decrease of yield stress and the increase of hardening exponent and elastic modulus.The average deviation angle of upper surface increases with the increase of yield stress and the decrease of hardening exponent and elastic modulus.The average deviation angle of lower surface increases with the decrease of yield stress.hardening exponent and elastic modulus.Meanwhile,the corresponding variation ranges are given.The achievements may serve as an important guide for selecting the reasonable processing parameters of splitting spinning based on different aluminum alloys,and are very significant for optimum design and precision control of the splitting spinning process.
其他文献
Construction of integrated database including casting shapes with their casting design,technical knowledge, and thermophysical properties of the casting alloys
The microstructures of Ti6A14V alloy after hydrogenation were investigated by optical microscopy (OM), X-ray diffraction (XRD) and transmission electron microsc
A new ultrasonic three-point bending fatigue test device was introduced to investigate fatigue life ranging up to 1010 cycles and associated fracture behavior o
CFRP(carbon fiber reinforced plastics)composite materials have wide applicability because of their inherent design flexibility and improved material properties.
Recently,demand for the lightweight alloy in electric/electronic housings has been greatly increased.However, among the lightweight alloys,aluminum alloy thin-w
2×(FeNi/CoZnO)/ZnO/(CoZnO/Co)×2 spin-inJection devices were prepared by sputtering and photo-lithography. In the devices, two composite magnetic layers 2×(Fe
Taguchi approach was applied to determine the most influential control factors which will yield better tensile strength of the joints of friction stir welded RD
In this work,alpha(α)brass was poured in green sand mould and metallic chill mould at about 1050℃. Sand casting method and metallic chill casting method are r
The bioleaching behavior of low-grade copper sulphides under the condition of preferential solution flow was investigated through experiments.The experiment of
Multiple-metal catalysts (Ni-Mn-Ce-K/bauxite) for Water-Gas Shift (WGS) reaction were prepared by impregnation, and the catalytic structure and properties were