【摘 要】
：
The tribological behavior depends significantly on friction heat under high sliding velocity. Many factors influence the conduction rate of friction heat, such
【机 构】
：
School of Mechatronic Engineering,Theory of Lubrication and Bearing Institute,School of Material Sci
论文部分内容阅读
The tribological behavior depends significantly on friction heat under high sliding velocity. Many factors influence the conduction rate of friction heat, such as thermophysical properties of the pairs, the formation components of interface-film, environment mediums, etc. Through theoretical and experimental studies on surface temperature, the heat partition approaches have been applied to the pairs of M2 steel against GCr15 steel to compare and discuss their tribological behavior in dry sliding contact. The results indicate that the values of the contact pressure have little effect on the heat partition at a high sliding velocity of 40 m/s. Furthermore, the degree of correlation between the dynamic temperature and friction coefficient is obvious, and the correlation degree of parameters increases as the pressure grows. A close correlation exists among the temperatures measured from different points of the pin specimen. At last, X-ray diffraction analysis denotes that the carbides of secondary M6C are separated out during the process of friction.
其他文献
The numerical non-stability of a discrete algorithm of topology optimization can result from the inaccurate evaluation of element sensitivities. Especially, whe
从序关系的角度研究多准则决策问题,提出了基于序关系和粗糙集理论的多准则决策方法的系统流程.针对传统定性转换方法信息丢失和导致信息表不一致的缺陷,提出了一种新的定量
Accelerated corrosion test of stainless steel with weld was carried out to investigate the corrosion behavior under the wetdry cyclic condition in the atmospher
Circular impinging jet, which is widely used in accelerated control cooling (ACC) equipment to accelerate the cooling of hot rolled plates, is subject to breaku
The influence of annealing time on the magnetic properties and microstructure of nanocomposite Pr7.5Dy1Fe71Co15Nb1B4.5 ribbons was systematically investigated b
(Pt/Co)n/FeMn multilayers with perpendicular anisotropy (PA) were prepared by magnetron sputtering with Pt as the buffer layer and the capping layer. The depend
BaPbO3 thin films were deposited on Al2O3 substrates by sol-gel spin-coating and rapid thermal annealing. The microstructure and phase of BaPbO3 thin films were
(La, N) co-doped TiO2 photocatalysts were synthesized using TiCl4 sol-gel autoigniting synthesis (SAS) starting from a plished in the formation of TiO2 nanocrys
在公路桥梁工程施工管理中，合同管理对于明确施工单位的义务和责任发挥着极大的约束力。良好的合同管理对于控制工程成本，避免出现成本消耗和经济损失有着显著的意义。下文就对
This paper presents a new chiral separation technology: two-phase (O/W) recognition chiral extraction. Distribution behavior of α-cyclohexyl-mandelic acid enan