论文部分内容阅读
模型是威龙出品的老板件,编号为3533,当时只是为了图便宜,买到手才发现很多细节都要自己改,改造细节如下:1、用铜棒替代炮塔围栏;2、铜丝替代牵引锁,同时用塑料自制U型钩环;3、用铜丝添加车体前部扶手电线及脚蹬;4、铜棒自制炮盾同轴机枪并用铜棒铝片添加7.62毫米口径机枪扳机;5、用0.2毫米胶板自制所有潜望镜,方法是正面遮喷黄边,反面喷郡仕透明红色;6、左前大灯的防护框被我搞坏了,用胶板重做;7、用胶板重做左前方挡泥板,并刻出老板件没有开出的前挡泥板的X型防滑纹,加深一些炮塔上方的一些刻线;8、最后说下骷髅旗的制作,先用铝片裁出旗帜大小并造型出飘动感,再用铜棒做旗杆,用AB补土塑形出旗子与旗杆的连接处。剪剪磨磨钻钻的事情就不再赘述了,制作过程介绍到此为止。
Model is Veyron produced the boss pieces, number 3533, was only to map cheaper, buy hands only to find a lot of details must be changed, the details of the transformation are as follows: 1, with copper bars instead of turret fence; 2, copper instead of traction lock , At the same time with plastic self-made U-shaped hook and loop; 3, with copper wire to add front body armrest wires and pedals; 4, copper rod homemade gun shield coaxial machine gun and add copper rod aluminum sheet 7.62 mm caliber machine gun trigger; Made with 0.2 mm plastic sheeting all the periscope, the method is the positive blinds yellow edge, the opposite Penheyes transparent red; 6, the left headlight of the protective frame was ruined, with a plastic sheet to redo; 7, Do the left front fender, and carved out the boss did not part out of the front fender X-type non-slip pattern, deepen some turrets above some of the engraving; 8, finally said under the skull flag production, first with aluminum cut The size of the flag and the shape of the floating sense, and then use copper rods do flagpoles, AB complement plastic flag and flagpole connection. Trimming and grinding diamond drilling things will not repeat them, the production process so far.