论文部分内容阅读
本文对微型轴承采用无基准端面加工法的一些有关问题，进行了初步探讨。指出，在用这种加工方法时，套圈的滚道侧摆，端面跳动及沟道位置，都要受到有关因素的影响。对这些影响，文章利用示图，结合数学方法进行了分析，得出了它们之间对应关系的具体关系式。为消除各因素的影响。从工艺上采取了三点措施。文内简述了采用无基准端面加工法的优点，并说明了这种方法的可行性。附图5幅。
In this paper, some problems related to micro-bearings using non-reference face machining method are discussed. It is pointed out that when using this kind of processing method, the ring side, side surface runout and channel position of the ferrule should be affected by the relevant factors. To these influence, the article uses the diagram, the mathematical method has carried on the analysis, has obtained the concrete relational formula between them correspondence. To eliminate the impact of various factors. From the craft to take three measures. The article briefly describes the advantages of using a non-reference face machining method and illustrates the feasibility of this method. Figure 5 Figure.