论文部分内容阅读
过去,调整多块瓦磨头轴承间隙时,很不方便。要先拆卸件8,再拆件7、件6,调整件4到一定间隙,装上件6,此时必须使端面碰到件4端面后再倒转2至3牙,再装上件7吊紧。此时,由于件7吊紧的影响,间隙会过大或过小。再要重新调整,又要依次拆卸、安装。这样,要调整到要求的间隙,往往需要反复好几次,既浪费了时间,操作又很繁琐。现在,我们在原有零件的基础上,增加了件5两个销子(附图),在件6
In the past, when adjusting the bearing clearance of multiple pieces of grinding head, it was very inconvenient. To disassemble 8, then disassemble 7, 6, adjusting member 4 to a certain gap, fitted with pieces 6, at this time must make the end face of the end face 4 and then inverted 2 to 3 teeth, and then loaded on the 7 tight. At this moment, the clearance may be too large or too small due to the tightness of the piece 7. To re-adjust, but also followed by disassembly, installation. In this way, to adjust to the required gap, often repeated several times, not only wasted time, the operation is very complicated. Now, on the basis of the original parts, we have added two pieces of pins 5 (with photos) and pieces 6