论文部分内容阅读
A current mode feed-forward gain control(CMFGC)technique is presented,which is applied in the front-end system of a hearing aid chip.Compared with conventional automatic gain control(AGC),CMFGC significantly improves the total harmonic distortion(THD)by digital gain control.To attain the digital gain control codes according to the extremely weak output signal from the microphone,a rectifier and a state controller implemented in current mode are proposed.A prototype chip has been designed based on a 0.13μm standard CMOS process.The measurement results show that the supply voltage can be as low as 0.6 V.And with the 0.8 V supply voltage,the THD is improved and below 0.06%(-64 dB)at the output level of 500 mV_(p-p),yet the power consumption is limited to 40μW.In addition,the input referred noise is only 4μV_(rms)and the maximum gain is maintained at 33 dB.
A current mode feed-forward gain control (CMFGC) technique is presented, which is applied in the front-end system of a hearing aid chip. Compared with conventional automatic gain control (AGC), CMFGC significantly improves the total harmonic distortion (THD) by digital gain control.To attain the digital gain control codes according to the most weak weak output signal from the microphone, a rectifier and a state controller implemented in current mode are.A prototype chip has been designed based on a 0.13 μm standard CMOS process The measurement results show that the supply voltage can be as low as 0.6 V. With the 0.8 V supply voltage, the THD is improved and below 0.06% (-64 dB) at the output level of 500 mV pp, yet the power consumption is limited to 40 μW. In addition, the input referred noise is only 4μV_ (rms) and the maximum gain is maintained at 33 dB.