论文部分内容阅读
1.装配要点(1)轴向柱塞泵有2个泄油口,安装时应将高处的泄油口接通往油箱的油管,使其无压漏油,而将低处的泄油口堵死。(2)泵的安装支架要有足够的强度,若管路过长需加装固定支架,以防振动。(3)采用弹性联轴器连接泵与驱动机构时,2根轴的同轴度应控制在0.2 mm以内。(4)必须保证管路及元件清洁,无杂物混入。(5)管路要经过耐压试验合格后才能安装,试验压力为工作压力的2倍;耐压
1. Assembly points (1) axial piston pump has two drain ports, the installation should be connected to the high-level drain pipe to the fuel tank, so that no pressure spills, and the lower the drain Port blocked. (2) The pump mounting bracket should have sufficient strength, if the pipe is too long to install a fixed bracket to prevent vibration. (3) When the flexible coupling is used to connect the pump with the drive mechanism, the concentricity of the two shafts should be controlled within 0.2 mm. (4) must ensure that piping and components clean, no debris mixed. (5) Pipeline to withstand voltage withstand test before installation, the test pressure is 2 times the working pressure; pressure