Ionic Liquid Modified Inorganic Nanopartieles for Gaseous Phenol Adsorption

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:woodcock9
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Ionic liquid modified silica nanoparticles were synthesized using a simple silane chemistry,followed by substitution reaction.The phenol adsorption performance was tested using temperature programmed desorption technique.The experimental results reveal that the introduction of ionic liquids on the surface of silica nanoparticles can improve the adsorption capacity of phenol compared to the pure silica nanoparticles.The initial adsorption capacity reaches 0.312 mmol·g-1 at 25 ℃ under total pressure of 0.2 bar and it decreases slightly in the following adsorption-desorption cycles.The results demonstrate that introduction of ionic liquids can improve the phenol adsorption capacity and the simple material preparation process is feasible for industrial applications.
其他文献
Rice husk ash/natural rubber composites were fabricated by modifying rice husk ash with the rare earth coupling agent DN-8102. The structure of the rice husk ash and the morphological dispersion of the rice husk ash in a rubber matrix were charactered by
Fe-based coatings reinforced by spherical tungsten carbide were deposited on 304 stainless steel using plasma transferred arc (PTA) technology. The composition and phase microstructure of the coatings were evaluated using scanning electron microscopy (SEM
The thermal emittance of Cr film, as an IR reflector, was investigated for the use in SSAC. The Cr thin films with different thicknesses were deposited on silicon wafers, optical quartz and stainless steel substrates by cathodic arc ion plating technology
Long (15-40 μm),thin (diameter of 20 ± 5 nm),and well-dispersed CuNWs Cu nanowires were prepared.The high-resolution TEM and selected area electron diffraction showed that the CuNWs were single-crystalline.To investigate the growth mechanism,we examined t
Organically modified montmorillonite (OMMT) was incorporated into the complex of 18-crown-6 (CE) and polyimide-croum ether (PI[CE]), and its effect on the properties of the complex was evaluated in terms of thermal behaviors, coefficient of thermal expans
A combination of experimental measurements and numerical analysis was utilized to study the low-velocity impact damage of domestic carbon fiber-reinforced composites (CFRCs). The results indicated that the low-velocity impact damage induced pits and longi
A Fe modified Na2WO4 compound was synthesized by a solution impregnation method and was ball-milled with MgH2 to constitute a novel MgH2-Fe2O3/Na2WO4 composite. The effects of the Fe2O3/Na2WO4 additive on the hydrogen storage properties of MgH2 together w
Using lignite-based hypercoal as raw material, KOH as activator and CuO as microwave absorber, we prepared hypercoal-based activated carbons by microwave-assisted activation. The pore structure and the electrochemical performance of the activated carbons
The amorphous I/Au composite nanofilms were prepared by low vacuum direct current sputtering (LVDCS) method. The optimized preparation technologies contain growth pressure, time, gaseous environment and annealing conditions. The maximum fluorescence emiss
Chitosan (CS), hydrated zinc acetate, and rectorite (REC) were used as raw materials to prepare CS-embedded zinc oxide (ZnO) nanoparticle by a chemical precipitation process. Hydrogen-bonded REC-loaded ZnO-CS nanoparticle was to form ZnO-CS/REC nanocompos