论文部分内容阅读
A TiAl base alloy ingot with a height to diameter ratio of 2.2 was broken down by multiple step canned forging. The microstructures after every deformation and subsequent recrystallization were observed by optical microscopy. Results show that at the first step the reduction should be carefully controlled in case of double bulge and crack of the ingot. After the first annealing, recrystallization occurred at the deformed grain boundaries and inside the grain. The recrystallized microstructure is favorable for further deformation. After the second deformation and annealing, coarsening of the lamellae occurred and the microstructure became equiaxed. By the final deformation and subsequent recrystallization, the coarse lamellar colony can be refined to about 20 μm, and homogeneous microstructure was obtained from the ingot with a large initial height to diameter ratio.
A TiAl base alloy ingot with a height to diameter ratio of 2.2 was broken down by multiple step canned forging. The microstructures after every deformation and subsequent recrystallization were observed by optical microscopy. Results show that at the first step the reduction should be carefully controlled in case of double bulge and crack of the ingot. After the first annealing, recrystallization occurred at the deformed grain boundaries and inside the grain. The recrystallized microstructure is favorable for further deformation. After the second deformation and annealing, coarsening of the lamellae occurred and the By the final deformation and subsequent recrystallization, the coarse lamellar colony can be refined to about 20 μm, and homogeneous microstructure was obtained from the ingot with a large initial height to diameter ratio.