【摘 要】
：
In order to develop high-efficiency and low-cost catalyst for the slurry-phase hydrocracking of vacuum residue (VR),the catalyst supported on natural rectorite was prepared,and the effect of calcination modification of rectorite on the catalyst properties
【机 构】
：
College of Chemical Engineering,Fuzhou University,Fuzhou,350108,China
论文部分内容阅读
In order to develop high-efficiency and low-cost catalyst for the slurry-phase hydrocracking of vacuum residue (VR),the catalyst supported on natural rectorite was prepared,and the effect of calcination modification of rectorite on the catalyst properties and performance was investigated.The support of rectorite and catalyst were characterized by XRD,FTIR,Py-FTIR,H2-TPR and XPS to examine their structures and properties.The comparative reaction results show that VR conversions for the catalysts supported on calcined rectorite were similar with that on raw rectorite,possibly due to the VR cracking reaction controlled by the thermal cracking following free radical mechanism because of few acid sites observed on the catalysts surface.However,the yields of naphtha and middle distillates for the various catalysts were obviously different,and increased following as Rec-Mo (40.4 wt％) ＜ Rec-600-Mo (52.7 wt％) ＜ Rec-450-Mo (53.5 wt％) ＜ Rec-500-Mo (61.7 wt％),indicating that the calcination of rectorite favored the enhancement of the yields of naphtha and middle distillates for the catalyst in the slurry-phase hydrocracking process,it is attributed that the higher sulfidation degree of molybdenum oxide species on the catalyst surface promoted hydrogenation reaction,thus restrained over-cracking reaction of in-termediate product to produce gas.
其他文献
This work presents the design of a robust foam formulation that tolerates harsh reservoir conditions(high salinity,high divalent ion concentration,high temperature,light oil,and hydrocarbon injection gas)in a sandstone reservoir.For this,we selected anion
Loss of drilling fluids in large porous and fractured zones inevitably up-regulates the overall cost of drilling.As a type of acid-soluble cement,magnesium oxysulfate(MOS)cement is arousing huge attention for the less hygroscopic nature and less damaging
This work aimed at investigating the crucial factor in building and maintaining the combustion front during in-situ combustion(ISC),oxidized coke and pyrolyzed coke.The surface morphologies,elemental contents,and non-isothermal mass losses of the oxidized
Proppant is a key material for enhancing unconventional oil and gas production which requires a long distance of migration and efficient liquid conductivity paths within the hydraulic fracture.However,it is difficult to find a proppant with both high self
Drilling in a natural gas hydrate formation is challenging due to the poor consolidation of the formation and the potential evaporation of the hydrate.The unreasonable down-hole pressure of the drilling fluid can not only lead to the wellbore instability,
To improve the cracking behavior of hydrocarbon,Ni-Mo/SiO2 bimetallic catalysts were synthesized by different preparation methods(sol-gel,co-impregnation and single-impregnation)and added the ad-ditives(citric acid,polyethylene glycol and cetyltrimethylam
Regulating rheological properties of water-based drilling fluids has always been a hot topic.This paper proposed a new method for regulating rheological properties of water-based drilling fluids by ultrasonic field.The experimental results showed that the
Cone-straight nozzle has been widely used in well bore cleaning,assisting drilling in petroleum in-dustries due to its good clustering properties.The structure including cone angle and throat length has also been studied by scholars and been optimized.How
In order to effectively control petroleum hydrocarbon pollution by immobilisation technology,it is necessary to understanding the degradation pathways of petroleum hydrocarbon in immobilised petroleum-degradation bacteria system.However,the adsorption in
Polymer gel systems have been widely applied to control excessive water and improve oil recovery (IOR)in petroleum reservoirs.They are usually divided into two main types,in-situ cross-linked polymer gels,and pre-formed polymer gels.In recent years,nuclea