论文部分内容阅读
在混凝土预制构件厂,运送混凝土拌合物的方式一般有两种,即汽车运送和输送小车运送。前者用于浇灌现场远离搅拌机的情况,后者用于生产车间和搅拌楼相距甚近的情况。由于输送小车所运送的料来自搅拌楼,因此它的料斗上皮标高必须低于搅拌楼出料溜子底皮标高。又由于它要把料倾卸在车间地坪上沿纵向行驶的浇灌机内,所以输送小车的行驶轨道,必须高于浇灌机上口标高。因此,在单跨或多跨成型车间山墙处,常设有夹层,小车在此夹层轨道上沿车间横向行驶,就可以满足上述标高要求,并能把
In the concrete prefabricated component factory, there are generally two methods for transporting concrete mixes, namely the transportation of cars and the transport of transport cars. The former is used to irrigate the site away from the mixer and the latter is used when the production plant and the mixing plant are closely spaced. Since the material conveyed by the transport trolley comes from the agitation building, its scalar upper skin elevation must be lower than the elevation of the bottom of the agitator floor. And because it has to dump the material in the watering machine running longitudinally on the floor of the workshop, the transport track of the transport trolley must be higher than the elevation of the watering machine. Therefore, in the single-span or multi-span molding workshop gables, there is often a sandwich. The trolley travels along the horizontal direction of the workshop on this sandwich track to meet the above elevation requirements and can