AIS—10型厌氧浸渗剂及其工艺的研究

• 作 者: 王美玉 向能宽 郑超 常玉鑫
• 机 构: 武汉材料保护研究所防锈室 工程师,工程师
• 出 处: 材料保护
• 发表日期: 1985年01期
• 关键词: 浸渗剂 AIS 压铸件 厌氧 乐泰公司 机械制造 试压 单体组成 机器厂 室温固化

一、前言在机械制造中,受压的铸件,因结构疏松,表面有针孔等缺陷,往往在加工成成品后试压时,出现泄漏,冒汗等现象,达不到设计要求而大量报废。为此,虽曾采用多种方法,惜都未能完全解决。六十年代中期,美国乐泰公司研制生产了一种厌氧浸渗剂—PMS—10E型浸渗剂。它既能防止受压铸件泄漏,又能节约材料和能源,因此受到国际上的普遍重视。

First, the preface In machinery manufacturing, the pressure castings, due to the loose structure, the surface of pinholes and other defects, often processed into finished pressure test, the emergence of leakage, sweating and other phenomena, not meet the design requirements and scrapped . To this end, although a variety of methods have been used, but unfortunately failed to completely solve. The mid-1960s, the United States Loctite developed an anaerobic infiltration agent-PMS-10E type infiltrant. It not only prevent the leakage of the compression casting, but also save material and energy, so it is universally valued.