论文部分内容阅读
Most major oil zones in the Daqing Oilfield have reached a later,high water cut stage,but oil recovery is still only approximately 35%,and 50%of reserves remain to be recovered.The remaining oil is primarily distributed at the edge of faults,in poor sand bodies,and in insufficiently injected and produced areas.Therefore,the edge of faults is a major target for remaining oil enrichment and potential tapping.Based on the dynamic change of production from development wells determined by the injection-recovery relationship at the edge of faults,we analyzed the control of structural features of faults on remaining oil enrichment at the edge.Our results show that the macroscopic structural features and their geometric relationship with sand bodies controlled remaining oil enrichment zones like the edges of NNE-striking faults,the footwalls of antithetic faults,the hard linkage segments(two faults had linked together with each other to form a bigger through-going fault),the tips of faults,and the oblique anticlines of soft linkages.Fault edges formed two types of forward microamplitude structures:(1) the tilted uplift of footwalls controlled by inverse fault sections and(2) the hanging-wall horizontal anticlines controlled by synthetic fault points.The remaining oil distribution was controlled by microamplitude structures.Consequently,such zones as the tilted uplift of the footwall of the NNW-striking antithetic faults with a fault throw larger than 40 m,the hard linkage segments,the tips of faults,and the oblique anticlines of soft linkage were favorable for tapping the remaining oil potential.Multi-target directional drilling was used for remaining oil development at fault edges.Reasonable fault spacing was determined on the basis of fault combinations and width of the shattered zone.Well core and log data revealed that the width of the shattered zone on the side of the fault core was less than 15 m in general;therefore,the distance from a fault to the development target should be larger than 15 m.Vertically segmented growth faults should take the separation of the lateral overlap of faults into account.Therefore,the safe distance of remaining oil well deployment at the fault edge should be larger than the sum of the width of shattered zone in faults and the separation of growth faults by vertical segmentation.
Most major oil zones in the Daqing Oilfield have reached a later, high water cut stage, but the oil recovery is still only about 35%, and 50% of the reserves remain to be recovered. The remaining oil is distributed at the edge of faults, in poor sand bodies, and in insufficiently injected and produced areas. agofore the edge of faults is a major target for remaining oil enrichment and potential tapping.Based on the dynamic change of production from development wells by the the injection-recovery relationship at the edge of faults, we analyzed the control of structural features of faults on remaining oil enrichment at the edge. Here results show that the macroscopic structural features and their geometric relationship with sand bodies controlled remaining oil enrichment zones like the edges of NNE-striking faults, the footwalls of antithetic faults, the hard linkage segments (two faults had linked together with each other to form a bigger through-going fault), the tips of faults, and the oblique anticlines of soft linkages. Fault edges formed two types of forward microamplitude structures: (1) the tilted uplift of footwalls controlled by inverse fault sections and (2) the hanging-wall horizontal anticlines controlled by synthetic fault points. The remaining oil distribution was controlled by microamplitude structures. Classical, such zones as the tilted uplift of the footwall of the NNW-striking antithetic faults with a fault throw larger than 40 m, the hard linkage segments, the tips of faults, and the oblique anticlines of soft linkage were favorable for tapping the remaining oil potential. Multi-target directional drilling was used for remaining oil development at fault edges. Reasonable fault spacing was determined on the basis of fault combinations and width of the shattered zone. Well core and log data revealed that the width of the shattered zone on the side of the fault core was less than 15 m in general; therefore, the distance from a fault to the development targetshould be larger than 15 m. Vertically segmented growth faults should take the separation of the lateral overlap of faults into account.Therefore, the safe distance of remaining oil well deployment at the fault edge should be larger than the sum of the width of shattered zone in faults and the separation of growth faults by vertical segmentation.