Effect of Temperature on the Dynamic Recrystallization of AZ31 Alloy with Pulse Current

来源 :金属学报(英文版) | 被引量 : 0次 | 上传用户:nishi1221
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The tensile tests of AZ31 magnesium alloy were carried out under room temperature,100,150 and 200 ℃ with and without pulse current.The effect of temperature on dynamic recrystallization (DRX) of AZ31 alloy was studied at different conditions.One-parameter approach was used to analyze the critical conditions of DRX,the critical stress was obtained under different temperatures,and the related results were validated by metallography observation.The results showed that DRX of AZ31 alloy occurred at 200 ℃ without pulse current.When pulse current with 150 Hz/50 V parameter was applied at room temperature,DRX occurred,while DRX was not completed until temperature over 150 ℃.With the analysis result of critical conditions of DRX based on one-parameter approach,the relationship between critical stress and peak stress obtained in this present study is σc =(0.746-0.773)σp.
其他文献
Powder mixture of ball-milled aluminium and functionalized multi-walled carbon nanotubes was compacted via spark plasma sintering (SPS) to study effects of sintering temperature and heating rate.An increase in sintering temperature led to an increase in c
In this work,the electrochemical behaviors of SAM2X5 Fe-based amorphous alloy coating and hard chromium coating were comparatively studied in 3.5 wt% NaC1 solution.In comparison with the hard chromium coating,the SAM2X5 coating exhibited a wider and stabl
The precipitation characteristics and mechanism of vanadium carbides during isothermal transformation at 650 ℃ in a V-microalloyed medium-carbon steel were investigated through scanning electron microscopy and transmission electron microscopy as well as d
Perovskite BaTiO3 (BTO) nanocrystals with a size of 150-200 nm have successfully been synthesized via a facile hydrothermal method by employing titanate nanowires as synthetic precursor.Tetragonality and spontaneous ferroelectric polarization of BTO nanoc
The σ-phase precipitation in 20% cold-worked 15Cr-15Ni titanium-modified austenitic stainless steel was studied during long-term aging treatment.During the isothermal aging stage,the amount of σ-phase was significantly increased at beginning and gradually
It has been widely demonstrated that addition of Ni in low-carbon steels can effectively improve the cryogenic toughness,but the mechanism behind it has yet to be clarified.In the present work,the evolutions of microstructure and mechanical properties aft
2.98 kGy/h (1007 h) gamma irradiation and 90 ℃ (2000 h) thermal aging were exerted to X65 grade low carbon steel buried in Gaomiaozi bentonite containing 17 wt% Beishan groundwater.The average corrosion rate of X65 low carbon steel was measured.The elemen
The effect of electropulsing on the mechanical behaviors and microstructures of Ti-6Al-4V titanium alloy was investigated by an uniaxial tensile test.Compared to the value measured in cold tensile test,the alloy exhibits lower ultimate tensile strength wh
Despite the economy of material cost and excellent toughness of Cu-based amorphous alloys,especially Cu5oZr5o,their poor corrosion resistance to a chloride medium limits their widespread applications.In this study,corrosion tests were performed on the Cu5
The hot deformation characteristics and the corrosion behavior of a high-strength low-alloy (HSLA) steel were investigated at deformation temperatures ranging from 800 to 1100 ℃ and strain rates ranging from 0.1 to 10 s-1 using an MMS-200 thermal simulati