【摘 要】
：
In this paper, the hydrodynamically generated noise by the flow over an open cavity is studied. First, aeroacoustic theories and computational aeroacoustic(CAA)
【机 构】
：
School of Mechanical Engineering
论文部分内容阅读
In this paper, the hydrodynamically generated noise by the flow over an open cavity is studied. First, aeroacoustic theories and computational aeroacoustic(CAA)methodologies are reviewed in light of hydrodynamic acoustics, based on which, a hybrid method is presented. In the coupling procedure, the unsteady cavity flow field is computed using large-eddy simulation(LES), while the radiated sound is calculated by the Ffowcs Williams-Hawkings(FW-H)acoustic analogy with acoustic source terms extracted from the time-dependent solutions of the unsteady flow. The hybrid LES-FW-H acoustic analogy method is tested with an open cavity flow at Mach number of 0.006 and Reynolds number of 105. Following the reflection theorem of Powell, the contributions from different source terms are quantified, and the terms involving wall-pressure fluctuations are found to account for most of the radiated intensity. The radiation field is investigated in the frequency domain. For the longitudinal direction, the sound propagates with a dominant radiation downstream the cavity in the near-field and a flatter directivity in the far-field, while for the spanwise direction, the acoustic waves have a similar propagation along +z and-z directions, with no visible directivity.
其他文献
An optimum design model has been proposed for carbon/carbon ablative property based on genetic algorithm,in which the optimum parameters are the number of woven
In this paper, the wind load on an arc-shaped canopy roof was studied with numerical wind tunnel method(NWTM). Three-dimensional models were set up for the cano
In mod manufacturing patt, there are many uncertain factors in the mod manufacturing process, such as changes of product attribute, changes of manufacturing res
Many simple nonlinear main journal bearing models have been studied theoretically, but the connection to existing engineering system has not been equally invest
In the pedestrian headform impact test mandated by the European pedestrian safety requirements, the contact friction between the headform and the engine hood af
The densities of CO_2 inclusions in minerals are commonly used to determine the crystallizing conditions of the host minerals. However, conventional microthermo
This work is aim at studying the dependence of fission yields on incident neutron energy,so as to produce evaluated yield sets of the energy dependence.Experime
The problem of leak location is actually a time delay estimation (TDE) problem. Since most exist-ing TDE methods may encounter the problem of high computational
An accurate circuit of PWM/PFM mode converting and a circuit of auto-adaptively adjusting dimension of power transistor are described. The duty cycle of the sig
The settlement substrates of nona-porous abalones (Haliotis diversicolor supertexta) are covered with biofilms in which several types of microorganisms coexist