论文部分内容阅读
我校与电子工业部第46所合作研制的齿轮研合剂(原名齿轮研光剂),能在满载下使齿轮得到快速研合,并且不会产生胶合等损伤,很好地解决了国内外过去没有解决的在满载下使齿轮得到快速研合的问题。用研合剂研合后的齿轮,各单项精度都有所提高。齿面粗糙度可以明显降低,齿轮接触面可达100％,基节精度和齿形精度可提高一级。 由于研合可以在满载下进行,研合后的轮齿,已经消除了安装误差和各种变形误差。其结果不但相当于进行了各种修形,而且“修形”量是最符合实际的。因此,用这种研合剂研合,
Our school and the 46th Ministry of Electronics Industry developed gear grinding agent (formerly gear grinding agent), can be fully loaded under the gear to quickly research, and will not produce glue and other damage, a good solution to the past at home and abroad Unresolved problems with rapid gear grinding under full load. After grinding with the research agent, each single precision has been improved. Tooth surface roughness can be significantly reduced, the gear contact surface up to 100%, base accuracy and tooth profile accuracy can be increased by one. As the research can be carried out under full load, after the study of gear teeth, has eliminated the installation error and a variety of deformation errors. The result is not only equivalent to a variety of repair, and “repair” the amount is the most realistic. Therefore, with this research agent,