论文部分内容阅读
为落实全军除害灭病规划,解决我部分散营区的饮用水消毒问题,我们设计了一种简易饮用水消毒装置,经试用效果良好。现介绍如下。材料 1.贮液桶1个,应有盖,能防锈、防腐蚀,其容积依用水量及有效消毒剂含量而定。 2.电磁阀1个。 3.流量调节开关1个。 4.优质塑料管,应无毒、耐压;孔径以5～10mm为宜;长度依贮液桶至水面下潜水泵汲水头距离而定。安装方法在常规洗井吊出水泵输水花管时,将塑料管下端与花管滤水孔连接并固定,上端与贮液桶消毒液出口相连。流量调节开关和电磁阀装于塑料管便于固定的位置。电磁阀导线接在水泵电机电源开关上,以实现电磁阀与水泵起动同步。工艺流程见附图。
In order to implement the plan of eliminating all kinds of diseases and eliminate all kinds of diseases in the entire army and to solve the problem of disinfection of drinking water in some of our scattered camping areas, we designed a simple drinking water disinfection device that has been tested well. Now introduced as follows. Material 1. Storage tank 1, should be covered, can rust, corrosion, and its volume according to the amount of water and effective disinfectant may be. 2 solenoid valve 1 3 flow control switch 1. 4. High-quality plastic pipe should be non-toxic, pressure; aperture to 5 ~ 10mm appropriate; length according to the bucket to the surface water submersible pump draw head distance may be. Installation method In the conventional well washing out of the pump water pipe, the lower end of the plastic pipe and flower pipe drainage holes connected and fixed, the upper end connected to the outlet of the liquid disinfectant. Flow control switch and solenoid valve installed in the plastic tube easy to fixed position. Solenoid valve wire connected to the pump motor power switch, in order to achieve solenoid valve and pump start synchronization. Process see photos.