论文部分内容阅读
用Clustercoil开卷纵剪法剪切金属卷料不是单一的,而是用一组刻有特殊V形凹痕的转刀把薄料纵剪成二条或更多条,同时,沿着卷料的长度方向留有极其微小的均匀的连接间隙。有单卷和多卷,多卷时,虽然暂时连在一起,但可能在以后某个时刻会断开,因此,要做好分开的准备工作。试验结果表明,适合于做这种工作的机械必须具有特殊的性能,Clustercoil纵剪机械与过去的纵剪机械之间就具有明显差别(图1)。首先,“Clustercoil”纵剪机切刀与
The use of Clustercoil uncoiling is not a simple method of slitting the web of material. Instead, the web is slitted into two or more slivers with a set of special V-shaped dents. At the same time, Leaving a very small uniform connection gap. There are single-volume and multi-volume, multi-volume, although temporarily connected together, but may be disconnected at some time in the future, so be prepared separately. Test results show that machines suitable for this type of work must have special properties, and there is a clear difference between the Clustercoil slitting machines and the past slitting machines (Figure 1). First, the “Clustercoil” slitting cutter with