【摘 要】
：
A study was conducted in a dual fuel engine to explore the influence of methanol mass ratio and compression ratio on the combustion characteristics,a set of methanol injection device was installed on
【机 构】
：
Taiyuan University of Technology
论文部分内容阅读
A study was conducted in a dual fuel engine to explore the influence of methanol mass ratio and compression ratio on the combustion characteristics,a set of methanol injection device was installed on a single cylinder diesel engine.The results show that,with the increase of the methanol mass ratio,the in-cylinder pressure gradually decreases,the pressure rise rate and the heat release rate increase firstly and then decrease,the start of combustion gradually postpone and combustion duration gradually short.The decrease of the compression ratio causes the increase of the peak heat release rate,but it has complex effects on the peak in-cylinder pressure,the peak pressure rise rate,start of combustion and combustion duration.When the compression ratio is 15.9,the peak in-cylinder pressure and the peak pressure rise rate are highest,the start of combustion is earliest and the combustion duration is longest.
其他文献
MEMS惯性导航产品由于其低廉的价格和体小质轻的特点在车辆导航定位应用中获得了广泛的青睐。但是MEMS器件相对于激光和光纤器件在定位及定姿精度上的欠佳表现，仍是其在L3级别及以上自动驾驶领域发展的最大阻碍。本文通过基于两种器件的数据融合算法，对MEMS组合惯性导航设备U-blox输出的航向角度数据进行了优化。优化后的航向角在精度、稳定性和平滑性上都较之前有了明显的提升。
本文对某自然吸气汽油机的三元催化器内流场分别进行了CFD稳态分析和瞬态分析，并一步对比两种方法优缺点。研究结果表明：由于发动机排气具有高温高压的特点，同时脉动特征明显，因此三元催化器在实际工作过程中，瞬时排气流场变化明显将会导致载体端面将呈现出明显的速度和温度差异。而采用稳态分析方法是基于时均边界条件来近似对实际瞬态过程进行评价。此方法假设各个时刻端面速度分布均匀性与排气流量存在一定程度线性关系，
The dynamics of boost control system in smart waste gate(WG)turbocharger is considered.The objective is to design and operate this system to avoid risk of resonance with pulse-width modulation(PWM)val
基于汽油机台架试验平台，对某款增压汽油机增压器断轴问题进行了试验研究。试验结果表明，汽油机在高速大负荷工况下，增压器压气机入口连接管路吸瘪，引起进气不畅，导致增压器转速异常偏高，超过设计转速50＃，进而引起增压器断轴失效。通过分析故障机理，提出改进方案，最终通过试验验证解决了增压器断轴问题。
In order to combine the advantages of high thermal efficiency of diesel engine and high power density of gas turbine,a new type of Diesel-Brayton Combined Cycle Engine scheme was put forward.The outle
In previous studies,Partially Premixed Compression Ignition(PPCI)combustion can obtain both good combustion controllability,performance and emissions in diesel engines with gasoline.This article focus
This study introduces the operating principle of dual mass flywheel(DMF),and establishes the dynamical equations of transmission system based on the theory of forced vibration and vibration reduction.
The exhaust temperature could be increased to heat DOC and promote DPF regeneration by part of cylinder deactivation in low load condition.In the article,with asymmetric exhaust system and EGR valve,c
this article through to the analysis of the camshaft timing gear product figure,combining with the characteristics of powder metallurgy parts forming and the production technology of the camshaft timi
In order to optimize the deblocking characteristics for a hydraulic motor driven CVVL system.We abstracted the working process of internal shaft actuator,and investigated the parameters which could si