【摘 要】
：
Shell-and-tube heat exchanger is a product with simple structure,mature technology and convenient use.The heat exchanger mentioned in this study is used in a vehicle exhaust heating system,which uses
【机 构】
：
Technical Center of Dongfeng Motor Group Co.,Ltd.
论文部分内容阅读
Shell-and-tube heat exchanger is a product with simple structure,mature technology and convenient use.The heat exchanger mentioned in this study is used in a vehicle exhaust heating system,which uses the exhaust heat of the engine to heat the air inside the vehicle,improve the internal heating effect of the vehicle in the cold season,realize waste turning into treasure,save energy and reduce emissions.In this study,CATIA three-dimensional software is used to carry out detailed modeling of heat exchangers.The flow path which is extracted from ANSYS software and simplified is divided into mesh.The appropriate boundary conditions are used to calculate the CFD three-dimensional numerical simulation,calculating the velocity field,temperature field and pressure field inside the fluid heat exchanger at different temperature inlets.The test platform is used to test the temperature field of the heat exchanger.The simulation results are in good agreement with the experimental test data,which provides a good research method for heat exchanger design and performance prediction.
其他文献
This study introduces the operating principle of dual mass flywheel(DMF),and establishes the dynamical equations of transmission system based on the theory of forced vibration and vibration reduction.
The exhaust temperature could be increased to heat DOC and promote DPF regeneration by part of cylinder deactivation in low load condition.In the article,with asymmetric exhaust system and EGR valve,c
this article through to the analysis of the camshaft timing gear product figure,combining with the characteristics of powder metallurgy parts forming and the production technology of the camshaft timi
In order to optimize the deblocking characteristics for a hydraulic motor driven CVVL system.We abstracted the working process of internal shaft actuator,and investigated the parameters which could si
A study was conducted in a dual fuel engine to explore the influence of methanol mass ratio and compression ratio on the combustion characteristics,a set of methanol injection device was installed on
This paper focuses on the impacts of injection and ambient temperatures on direct water injection in internal combustion enginesthrough experimental and numerical methods.Firstly,the study was carried
Firstly,the qualitative relationship is verified by test data between Secondary Dendrite Arm Spacing(SDAS)and tensile strength(σb),and the quantitative equation is σb =641.75(SDAS)-0.28,deduced by lin
The torsion beam mounting point,one of the important connection points between the car body and the chassis,is very important for the normal running and safety of passenger cars.The rear torsion beam
A hysteresis model under different loading rate is proposed based on measurement results with simple polynomial method.This model will be used for better control and compensation of pneumatic actuator
To explore the relationship between the supply air rate and the resistance of the cooling module itself,this paper provides a simulation method for cooling front module and single cooler supply air ra