Criteria and Parameters of Metal Magnetic Memory in Different Deformation Stages

来源 :首届内地与香港青年力学论坛2012(The 16th Annual Conference of Hong Kong So | 被引量 : 0次 | 上传用户：jenny18

【摘要】

：

　　Metal magnetic memory (MMM) is a new, passive magnetic non-destructive method, which is effective in characterizing the early damage of ferromagnets, especi

【出处】

：

首届内地与香港青年力学论坛2012(The 16th Annual Conference of Hong Kong So

【发表日期】

：

2012年3期

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　Metal magnetic memory (MMM) is a new, passive magnetic non-destructive method, which is effective in characterizing the early damage of ferromagnets, especially the micro-damage due to the local stress concentration.However, until now this technique can only find the "possible location of defects" due to lacking of convincible criteria and parameters.Experimental and numerical studies were performed in this study.

其他文献

热障涂层层级结构对强度的影响

　　热障涂层(TBC)被广泛应用于燃气轮机高温透平叶片，其由陶瓷层(TC)、热生长氧化层(TGO)和连接陶瓷层与高温合金基底的金属粘结层(BC)组成.热障涂层主要功能是隔热、抗氧化

会议

热障涂层界面形貌裂纹形式TGO强度

A Dynamic Increamental Hysteresis Model Incorporating Eddy Current Losses for Giant Magnetostrictive

　　This paper addresses the deveolopment of a magneto-elastic coupling dynamic hysteresis model for giant magnetostrictive materials(GMMs).Firstly, a three-dim

会议

Direct Numerical Simulation of Large Particle-laden Turbulent Channel flow Using Fictitious Domain M

　　It has been recognized that suspended particles can modify the characteristic of turbulent flow significantly.The fully-resolved direct numerical simulation

会议

Numerical Investigation of Bautin Bifurcation in a TCPAQM Congestion Control Model with State-depend

　　Theoretic research on the stability problem of Internet congestion control model has attracted much attention of researchers.Many nonlinear phenomena, such

会议

A Computational Method for Calculation of Residual Stresses Measured by Incremental Hole-Drilling Ap

　　In this work, a program complied by FORTRAN code dedicates to realize the residual stress calculation for multi depths with incremental hole-drilling method

会议

Model of Mismatched Contact for the Dislocation Generation During Coalescence of Grains

　　The presence of dislocations in crystals may be either detrimental or beneficial to their properties.Therefore, study on dislocation generation during cryst

会议

A Damage-coupled Time-dependent Multi-axial Fatigue Failure Model for Solder Alloy 63Sn-37Pb

　　Based on the time-dependent deformation behavior of solder alloy 63Sn-37Pb at room temperature, a damage-coupled unified visco-plastic multi-axial fatigue m

会议

Stretchable and Flexible Ferroelectrics Fabrication, Characterization and Theory

　　Lead zirconate titanate (e.g., PZT) is one of the most widely used ferroelectric materials, due to its excellent piezoelectric and ferroelectric properties.

会议

SH wave Transmission Properties in 1D Phononic Crystal With a Periodic Array of Interface Cracks

　　The interaction of anti-plane elastic SH waves with a periodic array of interface cracks in a one-dimensional phononic crystal is analyzed in this paper.A p

会议

Enhancement and Reduction of Heat Transport by Polymers with Finite Extensibility

　　We study how heat transport is affected by polymer additives in a steady-state boundary layer flow above a heated plate.We consider the FENE-P (finitely ext

会议

Criteria and Parameters of Metal Magnetic Memory in Different Deformation Stages

其他学术论文