【摘 要】
：
The typical amount of Mg added to hypoeutectic Al-Si alloys is ranged from 0.3 to 0.6 wt％.Mg addition over 0.6 wt％ induces residual Mg2Si precipitates during the solid solution treatment.Most of the w
【机 构】
：
Korea Institute of Industrial Technology, Korea
【出 处】
：
15th International Conference on Aluminium Alloys(ICAA15)(第十
论文部分内容阅读
The typical amount of Mg added to hypoeutectic Al-Si alloys is ranged from 0.3 to 0.6 wt％.Mg addition over 0.6 wt％ induces residual Mg2Si precipitates during the solid solution treatment.Most of the work on hypoeutectic Al-Si alloys containing Mg are limited to 0.1-0.6 wt％, and rarely exceeded 1 wt％ in the Mg contents.In the present study, Mg+Al2Ca master alloy as an alloying element of Mg was employed for the eutectic Si modification and control of Mg loss occurred during melting process.The purpose of this study is to investigate the changes of the microstructure and tensile property in AlSi7Mg alloys with Mg content range from 0.4 to 1.2wt％ during T6 heat treatment.
其他文献
The microstructure of Al-F.e binary ahoy processed by metal mould casting was investigated.The effects produced by Fe contents and the pouring temperature on the solidification structures of Al-Fe bin
During casting the semi-solid microstructure is frequently subjected to the tensile stresses, which are closely related to cast defects such as hot tearing, porosity and macrosegregation.To examine th
A low frequency electromagnetic field was introduced into the direct chill (DC) casting process and the ingots of Al-Cu alloy were prepared to study the macrosegregation behaviour of the ingots under
Developments of high-strength aluminum alloys have always faced a difficult problem: owing to their small size, the early-stage strengthening precipitates are difficult to characterize in terms of com
For decades, twin-roll casting has been applied for manufacturing aluminium alloy sheets.This conventional process contributes to make thin aluminium sheets from the molten metal directly.Recently, ve
Based on the green and saving concept, a complex process preparing semisolid alloy slurry was developed, which was composed of the low superheat pouring and low frequency electromagnetic stirring.The
The effect of cooling rate on the modification and refinement of 4032 aluminum alloy has been investigated at the cooling rates of 0.7～4.5 K/s, which is the range of mainstream industrial process.Sr a
The grain refinement and the corresponding mechanism of commercial purity Al solidified under pulsed magnetic field (PMF) was investigated in the present study.The experimental results clearly reveal
It is well known that solute content has significant effects on grain refinement of Al alloys, which is mainly due to the grain growth restriction factor.In this study, we investigated the influence o
Understanding the load behavior of high-strength wrought 7XXX-series aluminum alloys is very important for the analysis of hot tearing mechanism in direct-chill casting.A newly improved T type mold is