Surface Modification of Bamboo Fibers and Its Effect on Reinforcing Unsaturated Polyester Composites

来源 :The 11th China-Japan joint conference on Composite Materials | 被引量 : 0次 | 上传用户：syris

【摘要】

：

Bamboo fiber reinforced unsaturated polyester (UPE) composites were prepared by compression molding.Effects of morphology and chemical modification of fibers on the mechanical properties and water abs

【作者】

：

Renhui Qiu Wendi Liu Kaichang Li

【机构】

：

College of Material Engineering,Fujian Agriculture and Forestry University,Fuzhou,350002,P.R.China;D

【出处】

：

The 11th China-Japan joint conference on Composite Materials

【发表日期】

：

2014年3期

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

其他文献

Microwave Tunable Properties of Polymer Composites Containing Ferromagnetic Microwires

In the context of developing multi-functional composites [1],our efforts have been devoted in exploring ideal functional fillers that could meet the criteria: (i) a likely omnipotent functional filler

会议

Improvement of the CNT Twisted Yarn Using Cardo Epoxy Resin

CNT yarn is made from CNT bundles.But it is so low in tensile strength for the weak Van der Waals force of CNT each other.Therefore we aimed at the strength improvement of CNT yarn by impregnation of

会议

Carbon nanotube spun yarnCardo structureWeibull distributionBonding energy

Nanoscale Mass Sensor Based on the Vibration of Carbon Nanotube - Theoretical analysis of vibration

Carbon nanotubes (CNTs) are nanomaterials with extremely favorable mass sensor properties.In this paper,we proposed that CNTs under the clamped boundary condition and an axial tensile load were consid

会议

NanotubesSensorVibrationSimulation

Mechanical Properties of Untwisted Carbon Nanotube Yarn with Densification Treatment

CNT yarn is expected to be a good method for utilization of CNTs which have extremely high mechanical properties.In this study,we fabricate untwisted CNT yarn by drawing CNTs from vertically aligned C

会议

Untwisted CNT yarnPolymer treatmentTensile properties Unidirectional composite

Innovation of Polymer Based Functionally Graded Materials (FGMs)

Functionally graded multiwaIled carbon nanotube (MWCNT) reinforced epoxy matrix composites (FGMs) were innovated by using the centrifugal method;the aggregation of MWCNTs that occurred during the epox

会议

Functionally graded materials (FGMs)microwave absorptionCarbon nanotubegraded

Carbon Nanotube Decorated with Silver Nanoparticles and its electromagnetic Wave Absorption Properti

Silver (Ag) nanoparticles were fabricated by chemical reduction process,and then the Ag nanoparticles were grafted onto the surface of carbon nanotubes (CNTs) to prepare hybrid nanocomposites.

会议

Silver nanoparticlesCarbon nanotubesMicrowave absorber

Research on Crossed Nanostructure of a Cheek Tooth

The observation of a scanning electronic microscope on an adult cheek tooth shows that the tooth is a kind of natural bioceramic composite consisting of hydroxyapatite and collagen protein.

会议

大尺寸Nano-SiCp/AZ91D镁基复合材料的组织及其力学性能

采用超声波辅助搅拌铸造的方法，制备了体积分数为1％的纳米SiCp/AZ91D镁基复合材料的大尺寸铸锭。对其不同部位的组织进行观察发现，大尺寸铸锭外侧纳米颗粒分布相对内侧更为均匀，并且，不同部位的晶粒尺寸存在显著差异，铸态复合材料外侧上部晶粒相对内侧下部晶粒更为细小。复合材料不同位置颗粒分稚情况存在较大差异，部分位置可以观察到明显的团聚现象。力学性能测试结果表明：铸态复合材料外侧中部的力学性能最优，

会议

大尺寸铸锭纳米SiCp镁基复合材料颗粒分布

针叶树材木质素基碳纤维的力学性能

为提高针叶树材木质素基碳纤维的力学性能,通过熔融纺丝法制备的聚乙二醇木质素纤维先经过85℃的lHC1与C6H12N4混合水溶液化学固化lh,再在空气氛围中以一定的升温速率从室温加热至250℃氧化热稳定处理,制备得到无表面缺陷的不熔融纤维和经碳化后的碳纤维.研究表明,在化学固化过程中,由ChH12N4分解得到的甲醛分子在木质素分子中的苯环之间形成亚甲基键连接,提高了水质索分子的交联程度,并且在纤维表

会议

针叶树材木质索化学固化六次甲基四胺碳纤维力学性能

Preparation,Microstructure,and Properties of Activated Carbon Fibers Deriving from Liquefied Wood

Activated carbon fibers (ACF) were prepared from liquefied wood through liquefaction,melt-spinning,curing,carbonization,and stream activation.Their microstructure including crystal structure,surface m

会议

activated carbon fibersliquefied woodmicrostructureproperty

Surface Modification of Bamboo Fibers and Its Effect on Reinforcing Unsaturated Polyester Composites

其他学术论文