TEMPERING相关论文
Effect of induction heating and tempering on properties and microstructures of quenched and tempered
In this study,a C-Mn quenched steel tube was quickly tempered by induction heating,and the influence of the tempering te......
Corrosion-resistant-alloy (CRA) clad steel combines the good mechanical properties of the base material and the excellen......
本文研究了油淬温度对YG11C和YG20C硬质合金组织及性能的影响。将两种合金在1 000~1 250℃下进行油淬热处理,并于500℃回火,分析了......
压铸模如出现早期开裂,可能原因是压铸模合金成分偏析、淬火压力不够、冷速慢、截面改变处过渡角小等。可采用固溶淬火+高温回火,......
Neural network modeling to evaluate the dynamic flow stress of high strength armor steels under high
An artificial neural network(ANN) constitutive model is developed for high strength armor steel tempered at 500 C, 600 C......
Influence of Tempering Process on Mechanical Properties of 00Cr13Ni4Mo Supermartensitic Stainless St
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
Study on stable and meta-stable carbides in a high speed steel for rollers during tempering processe
A high speed steel(HSS) was studied for rollers in this work.The steel was quenched at 1150 C and tempered at 520 C.The ......
Precipitation behavior and martensite lath coarsening during tempering of T/P92 ferritic heat-resist
Tempering is an important process for T/P92 ferritic heat-resistant steel from the viewpoint of microstructure control,a......
Structural refinement of 00Cr13Ni5Mo2 supermartensitic stainless steel dur-ing single-stage intercri
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
Neural network modeling to evaluate the dynamic flow stress of high strength armor steels under high
An artificial neural network (ANN) constitutive model is developed for high strength armor steel tempered at 500 ?C, 600......
Effect of Tempering Temperature on Strength and Toughness of Novel Carbide-Free Bainite/Martensite D
The effect of tempering temperature on strength and toughness of the novel carbide free bainite/martensite (CFB/M) duple......
The local induction heating process and the whole induction heating process were adopted to develop the X80 φ1219 mm×2......
采用不同淬火、回火工艺对W6Mo5Cr4V2Si新型高速钢进行热处理工艺试验,并对材料的微观组织及硬度进行了分析.结果表明:W6Mo5Cr4V2S......
Low cycle fatigue behaviour of a steel 55NiCrMoV7 under four tempered conditions is reported. One special type of total ......
Experimental Study of Microstructure Evolution during Tempering of Quenched Steel and Its Applicatio
Microstructure evolution during tempering of quenched steel was studied via dilatometric experiments.Temperature ranges ......
利用金相技术、硬度测量及透射电子显微术,研究了Nb钢及Nb-Cu钢在525℃回火过程中的析出行为.结果表明:两种实验钢在850℃奥氏体化......
Effect of tempering temperature on microstructure and mechanical properties of high boron white cast
...
Through the differentiating and integrating process, a mathematical model for tempering time effect on quenched steel wa......
Structural refinement of 00Cr13Ni5Mo2 supermartensitic stainless steel dur-ing single-stage intercri
The 00Cr13Ni5Mo2 supermartensitic stainless steel was first tempered at 570-730°C for 2 h to observe the microstructure......
Precipitation behavior and martensite lath coarsening during tempering of T/P92 ferritic heat-resist
Tempering is an important process for T/P92 ferritic heat-resistant steel from the viewpoint of microstructure control, ......
Tempering is an important phenomenon in ferrous alloys. Most steels, especially alloy-ing steels, are used after quenchi......
对含0.63%C(质量分数)的铬钼耐磨铸在860℃保温1 h雾冷淬火和550℃回火2 h后分别油冷、空冷和炉冷。检测了钢的显微组织、硬度、冲......
利用JMatPro软件对合金覆层进行计算,模拟分析了不同回火状态下合金覆层内部相组成成分的变化情况与碳化物颗粒的析出情况,预测了......
