论文部分内容阅读
Ti——在i△t时间间隔时的温度。在实际热分析中,到底选用那个式子,分成多少个时间间隔,应视冷却曲线的具体情况而定。解决噪声干扰问题,用滤波器和数值微分法均可,但今后将比较多地用数字微分法。 2、气体分析液态金属中的气体分析,也有用真空熔化析出法等各种贵重仪器来分析的。对于铝合金等液态金属中的气体,也可在负压下利用液面变化来测定气体含量,以实现炉前分析。这种方法,以前多凭肉眼观察液面膨胀的情况,但今后将利用电荷偶合器件的图象传感器得到的信息,输入微处理机进行处理、判别的自动测试系统。 3、配料和加料量的计算如果已知液体金属的成分与要求的成分不符,必须计算出成分差额予以补加。
Ti - temperature at iΔt time interval. In the actual thermal analysis, in the end use that formula, divided into how many time intervals, depending on the cooling curve of the specific circumstances may be. Solve the problem of noise interference, using the filter and numerical differential method can be, but more will be more with the digital differential method. 2, gas analysis Liquid metal gas analysis, but also useful vacuum melting precipitation method and other valuable instruments to analyze. For aluminum and other liquid metals in the gas, but also under negative pressure can be used to determine the gas level changes in the liquid level in order to achieve pre-furnace analysis. In the past, liquid level expansion was observed by the naked eye. However, in the future, the information obtained by the image sensor of the charge coupled device is inputted to the microprocessor for processing and discriminating the automatic test system. 3, the calculation of ingredients and feeding amount If it is known that the composition of the liquid metal does not match the required composition, the difference in composition must be calculated to be added.