论文部分内容阅读
本文对“变位齿輪原理与应用”一书,从下列四个方面,提出了商榷性意見,如有錯誤之处,請讀者們提出指正。一、变位系数的选擇在条件限制方面不够完整在我們看来,如果应用滾刀加工的变位齿輪,一个关鍵性的限制——齿廓发生过渡曲綫干涉——不能不考虑。該书在推荐各种修正系統时,例如庫德略甫采夫(以下簡称庫氏)等制訂的变位系数表、格罗曼(以下簡称格氏)的变位系数图綫、噶甫利連科(以下簡称噶
In this paper, “the principle and application of gear” a book, from the following four aspects, put forward a concluding opinion, if there are any mistakes, please readers correct. First, the choice of coefficient of variation is not complete enough in terms of constraints In our opinion, if the hobbing hobbing gear shift, a key constraint - tooth profile transition curve interference - can not be ignored. The book in the recommendation of a variety of correction systems, such as Kudeliu Fu Tsev (hereinafter referred to as Ku) and other established coefficient of variation table, Groveman (hereinafter referred to as the Ge’s) coefficient of variation plot, Karma Julian Branch (hereinafter referred to as Karma