500公斤单柱蒸汽锤操作位置的改进

• 作 者: 黎光启
• 出 处: 锻压机械
• 发表日期: 1966年05期
• 关键词: 单柱 锻工 右所 主轴线 一条线 燕尾槽 锻件 一台 砧头 砧座

我厂一台500公斤单柱蒸汽锤,操作位置不合理(图1左),操作锻工与司锤工在一条线上,司锤工看不到锻件,使用很不方便。1963年我们将锻工操作位置改成45°位置,如图1右所示。为了作此改变,将下砧座进行修改。修改前的情况如图2左所示。改进后的情况如图2右所示,将原来的底座鉋低300毫米,另加一中座,此中座安装下砧头的燕尾槽与主轴线成

I plant a 500 kg single-column steam hammer, the operating position is unreasonable (Figure 1 left), forging and hammer operators in a line, the hammer can not see forgings, the use of very inconvenient. In 1963 we changed the location of forging operation to 45 °, as shown on the right of Figure 1. In order to make this change, the anvil was modified. The situation before the amendment shown in Figure 2 left. Improved situation shown in Figure 2 to the right, the original base planing 300 mm low, plus a seat, the seat installed anvil head dovetail and the main axis into