高技术开发区新模式——苏锡常火炬开发带

来源 :科学学与科学技术管理 | 被引量 : 0次 | 上传用户:csc000000
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
国家科委于1991年5月27日正式批准建立了“苏锡常火炬开发带”,这是一个不同于国家已批准的所有开发区的一种新的高新技术开发带,是我国高新技术开发区建设的一种新模式。目前已建设的高新技术开发区,都划有一定面积的区域,根据国务院规定,新建设的开发区一般不超过5平方公里,在原有的基础上建设的开发区面积不超过25平方公里,而且只有在这个区域内的高新技术企业才可享受国务院国发(91)12号文件的政策优惠。苏锡常火炬开发带不重新划分区域,而是在原苏锡常地区管辖的范围内,包括三市、12个县(市)进行高新技术开发区的建设。它不进行大规模的基建,不搞大规模的投资,坚持“利用已有的基础和条件,发 The State Science and Technology Commission formally approved the establishment of the “Suzhou, Wuxi and Changzhou Torch Development Belt” on May 27, 1991, which is a new high-tech development zone different from all the development zones that the country has approved. It is also a key area for the construction of China’s hi-tech development zone A new model. Currently, high-tech development zones that have been constructed are all zoned to a certain area. According to the regulations of the State Council, the newly-built development zones generally do not exceed 5 square kilometers. The development zones built on the original basis will not exceed 25 square kilometers and, Only high-tech enterprises in the region can enjoy the preferential policies of the State Council (91) No.12 Document. Instead of re-demarcating the development zones of the torch of the Soviet Union, Wuxi and Changzhou, the area under the jurisdiction of the former Soviet Union, Wuxi, Changzhou, including three cities and 12 counties (cities), will be set up to carry out high-tech development zones. It does not conduct large-scale infrastructure, do not engage in large-scale investment, adhere to the "use of existing infrastructure and conditions, made
其他文献
本文研究了30crMnsi钢调质一旋压一时效的形变热处理新工艺。钢材由供应状态先行淬火与高温回火(调质),然后进行形变量为50%的旋压和低温时效处理。旋压和时效使钢材抗拉强度
高速钢刀具的氧氮化,是在530~580℃下的氨和水蒸气的混合气氛中进行的热化学处理,使刀具表面形成一层氧氮化层,表层是磁性氧化铁膜,内层是氧氮扩散层。表层氧化膜能保存润滑
一、轧尖机1.用途:在钢丝穿模时用轧尖机将线材或钢丝端头锻细。2.分类:按原理分有两种类型,即锻打式和压延式。(1)迥转式锻尖机(一般叫旋锤)——锻打式 First, the rollin
我厂生产的汽轮机主汽门的15Cr11MoV钢阀杆、阀碟等零件,氮化后要求 HV≥650,渗层深度≥0.30mm,脆性≤3级。原采用普通氮化:530±10℃×20h,氨分解率25~30%;600±10℃×37h,
迄今,在金的萃取化学研究中,以中性含氧萃取体系为最多。我们曾对含有碳氧、硫氧和磷氧的萃取剂对金的萃取作过报道,新近,又有芳香氮氧化物用于金和铂族金属的萃取研究和金
本文就ISO关于分析试剂中砷的测定的一般方法作了理论上的详细说明。 This paper gives a detailed description of the general method of ISO for the determination of a
利用磷钼杂多酸测磷,这是众所周知的,但用于钼的测定,还未见报道。本文提出在含MoO_4~(2-)溶液中,过量PO_4~(3-)的存在下使之形成磷钼杂多酸,经抗坏血酸还原后,直接用于钼的
人们对于旅游的需求,近年来呈上升趋势,带动了我国旅游业的迅猛发展。海南作为我国旅游的热门城市,其丰富的旅游资源使其在竞争中占据绝对优势,但也不乏存在一些问题。论文简
附图所示磨直齿齿轮的夹具,在生产实践中证明是可靠的。当把齿轮(工件)装入后,用铜棒轻轻敲击几下,夹具的周边即可把齿轮准确地定心夹紧。制造该夹具时要注意使三个偏心凸块