论文部分内容阅读
Abrasive water jet cutting technology is widely applied in the materials processing today and attracts great attention from scholars,but many phenomena concerned are not well understood,especially in the internal jet flow of the cutting head at the condition of ultra-high pressure.The multiphase flow in the cutting head is numerically simulated to study the abrasive motion mechanism and wear inside the cutting head at the pressure beyond 300 MPa.Visible predictions of the particles trajectories and wear rate in the cutting head are presented.The influences of the abrasive physical properties,size of the jewel orifice and the operating pressure on the trajectories are discussed.Based on the simulation,a wear experiment is carried out under the corresponding pressures.The simulation and experimental results show that the flow in the mixing chamber is composed of the jet core zone and the disturbance zone,both affect the particles trajectories.The mixing efficiency drops with the increase of the abrasive granularity.The abrasive density determines the response of particles to the effects of different flow zones,the abrasive with medium density gives the best general performance.Increasing the operating pressure or using the jewel with a smaller orifice improves the coherency of particles trajectories but increases the wear rate of the jewel holder at the same time.Walls of the jewel holder,the entrance of the mixing chamber and the convergence part of the mixing tube are subject to wear out.The computational and experimental results give a qualitative consistency which proves that this numerical method can provide a reliable and visible cognition of the flow characteristics of ultra-high pressure abrasive water jet.The investigation is benefit for improving the machining properties of water jet cutting systems and the optimization design of the cutting head.
Abrasive water jet cutting technology is widely applied in the materials processing today and attracts great attention from scholars, but many marvels in are not well understood, especially in the internal jet flow of the cutting head at the condition of ultra-high pressure. The multiphase flow in the cutting head is numerically simulated to study the abrasive motion mechanism and wear inside the cutting head at the pressure beyond 300 MPa. Visible predictions of the particle trajectories and wear rate in the cutting head are presented. The influences of the abrasive physical properties , size of the jewel orifice and the operating pressure on the trajectories are discussed. Based on the simulation, a wear experiment is carried out under the corresponding pressures. The simulation and experimental results show that the flow in the mixing chamber is composed of the jet core zone and the disturbance zone, both both affect the particle trajectories. mixing mixing drops with the increase of the abrasive particleity. the abrasive density determines the response of particles to the effects of different flow zones, the abrasive with medium density gives the best general performance. Increasing the operating pressure or using the jewel with a smaller orifice improves the coherency of particles trajectories but increases the wear rate of the jewel holder at the same time. Walls of the jewel holder, the entrance of the mixing chamber and the convergence part of the mixing tube are subject to wear out. The computational and experimental results give a qualitative consistency which proves that this numerical method can provide a reliable and visible cognition of the flow characteristics of ultra-high pressure abrasive water jet. the investigation is benefit for improving the machining properties of water jet cutting systems and the optimization design of the cutting head.